Blank_Disk
Q: will this work on the tevo tornado?
Asked by daley2012 on 2020-12-14 02:00:44
Blank_Disk if it has the standard 2 cable layout or the 5 pin LCD, but you may have alter your firmware to accommodate the screen as all boards rely on the firmware to identify parts plugged in.
2020-12-14 04:04:58 Helpful (0)
Blank_Disk it's not possible, they are connected together permanently and run from the Z stepper so they cannot be controlled individually.
2020-10-24 02:44:17 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Blank_Disk depends on what you mean by extruder, as in reality, the motor is the extruder this is a hot end with three in one out, which means you would use a remote extruder, as is the motor attached elsewhere.
2021-11-20 03:23:09 Helpful (0)