All Messages

MBfromOK After further use I am sad to report that the screwdriver shaft has started slipping in the handle while trying to loosen manufacturer screws

MBfromOK 29/05/2020
1
Comments (1)

Q: What is the potentiometer and pushbutton cut-out size?

Asked by BG384414401 on 2021-06-01 04:42:41

MBfromOK Potentiometer:6.7 mm (.265 in) Max material thickness: (approximate) 4.17 mm (.166 in) Pushbutton: 15.75 mm (.620 in) Max material thickness: (approximate) 10.9 mm (.430 in)

2022-01-29 02:00:36 Helpful (0)
Submit
Answers (1)

MBfromOK No, they are under the glass layers and remove the use of about 30px of the touch interface, best way to hide it would be a bezel or black tape. Additionally, the screen is not backlit in this section.

2020-10-09 12:19:26 Helpful (0)
Submit
Answers (2)

Q: Can this be used on Arduino Mega without the shield? Thanks

Asked by johann.wongwork on 2020-03-27 08:48:47

MBfromOK While this can be plugged directly into the the Mega and has the R1 resistor pre-soldered... be warned that the logic for this is tft display is limited to 3.3v (by the chip manufacturer) if this display is actually getting near 5v it has a high likelihood of getting hot and failing early.David Prentice (the maker of the MCUFriend library) is all over the Arduino forums begging people to not use this display with the Mega, PI (and other 5v logic boards) without a using a logic level shifter.

2020-07-19 06:37:45 Helpful (1)
Submit
Answers (8)

Q: How to set celsius

Asked by Dudu Lasri on 2020-02-27 09:29:20

micahbeasley Comes in Celsius mode, while the thermometer is off, long press the power button (until C\F displays on screen) to switch between C\F modes.

2020-02-29 07:52:51 Helpful (0)
Submit
Answers (2)

Q: Thread type & Size?

Asked by micahbeasley on 2018-12-13 06:39:04

PampaWak Phisically, about 2cm, with one or two centimeters of error due to manual measurement. Technically, I don't know.

2020-02-02 02:58:51 Helpful (1)
Submit
Answers (1)

Q: Does this tool recognize the SAE J1850 VPW protocol?

Asked by micahbeasley on 2019-11-03 06:15:07

xiangjinhua I am also not certain.

2019-12-05 09:03:18 Helpful (0)
Submit
Answers (1)