KaperWrote 3513 days ago.With the help of 2 short C-beams (structural channels) can be used for Quanum Nova (or CX-20) with open access to 12V and 2 channels receiver output located at the bottom of the quad.
Comment
Overide2014-11-03 04:13:53
Hi,
I am looking at getting this gimbal for my CX-20.
Did you you put longer screws right through and just use the C section as a spacer?
Also what sizing C-section did you use, and did this give ...
By TEAMERICA14/04/2014This is a nice, well made gimbal. It might be very slightly heavier than a Carbon fiber gimbal but, for the money, you can't beat it. I noticed a couple things that are different from the images in this ad. 1. The wires are wrapped with spiral plastic wire wrap. 2. The sensor on the bottom of the camera platform is taped on instead of screwed on. It is very good two-sided tape so there is no problem. 3. The sensor is actually mounted on the other end of the camera platform - towards the motor which
By FyreSG01/06/2014I have to be really honest - this is not the best gimbal because of its weight and the slight occasional roll drift. However, consider its low price, and it does its job fine, I'm not complaining. I am able to hook this up on my CX-20 and carry a Mobius video camera and make nice aerial videos. CX-20 Mobius this gimbal = one of the _best bang for bucks_ deals! I did an video showing how to hook up the gimbal on YouTube. Check it out if you need help. :)