Compatibility
To confirm that this part fits your vehicle, please enter your vehicle's details below.
-
Year:
-
Make:
-
Model:
-
Submodel:
-
Trim:
-
Engine:
- Clear All
This part is compatible with 0 vehicle(s).
Show all compatible vehicles
This part is compatible with 1 vehicle(s) matching
This part is not compatible with
- Year
- Make
- Model
- Submodel
- Trim
- Engine
EleksZAxis is well compatible with EleksMaker A3 / A5 engraver, but you need to install it yourself:
Features:
- Suitable for holding laser module, spindle motor.
- This pecfect DIY kit can add an adjustable Z Axis to your engraver.
- If install it on EleksMaker A3 / A5 engraver, you need to replace the original ManaSE 2 Axis Board with
Mana 3 Axis Board
Warm Prompt: After adding a Z Axis on Elekslaser-A3 Pro, the laser head sticks out further than original position, which means the working area will be slightly reduced to about 380mm*220mm.
Package Included:
1 x EleksZAxis Holder
(Spindle Motor Not Included)
Notice: EleksZaxis is sent unassembledly, please refer to the instruction in wiki and assmble it by yourself:
Click Here, then test if it can move smoothly:
United Kingdom , USD
,
