I bought it for my DIY project with brushless racer star motors. The quality is ok, but the plastic ist only from 3D printer.

I bought it for my DIY project with brushless racer star motors. The quality is ok, but the plastic ist only from 3D printer.

I bought it for my DIY project with brushless racer star motors. The quality is ok, but the plastic ist only from 3D printer.

ok

ok

ok

Very good product

Very good product

Very good product

i tested and its very good,

i tested and its very good,

i tested and its very good,

Very Good!!!!

Very Good!!!!

Very Good!!!!

This build is so tight you cannot build it with the recommended parts without modification. I managed to build it. And it performs better than a TinyWhoop on 2S batteries, but it does not have great thrust to weight ratio. Final thrust-to-weight ratio with 2s 350mah was about 1.5-to-1, which is fine for "normal" flight, but does not allow for much in the way of acro capabilities. The TPU ducts are only attached at the center stack, and tend to flex and break blades if they strike anything.

This build is so tight you cannot build it with the recommended parts without modification. I managed to build it. And it performs better than a TinyWhoop on 2S batteries, but it does not have great thrust to weight ratio. Final thrust-to-weight ratio with 2s 350mah was about 1.5-to-1, which is fine for "normal" flight, but does not allow for much in the way of acro capabilities. The TPU ducts are only attached at the center stack, and tend to flex and break blades if they strike anything.

This build is so tight you cannot build it with the recommended parts without modification. I managed to build it. And it performs better than a TinyWhoop on 2S batteries, but it does not have great thrust to weight ratio. Final thrust-to-weight ratio with 2s 350mah was about 1.5-to-1, which is fine for "normal" flight, but does not allow for much in the way of acro capabilities. The TPU ducts are only attached at the center stack, and tend to flex and break blades if they strike anything.

frame is VERY tightly packed I haven't found a way to pack a 20x20mm piko flight board and 20x20mm racestar 4 in 1 ESP together in a way that allows the outer rings to be correctly lined up. can do with more and better quality parts for assembly as well. If you are not into puzzles do not buy!

frame is VERY tightly packed I haven't found a way to pack a 20x20mm piko flight board and 20x20mm racestar 4 in 1 ESP together in a way that allows the outer rings to be correctly lined up. can do with more and better quality parts for assembly as well. If you are not into puzzles do not buy!

frame is VERY tightly packed I haven't found a way to pack a 20x20mm piko flight board and 20x20mm racestar 4 in 1 ESP together in a way that allows the outer rings to be correctly lined up. can do with more and better quality parts for assembly as well. If you are not into puzzles do not buy!

I dont like the design , the blade guards are only supported by the 2,5 plastic stand offs in the middle ,and there is no way to support the outer edge of them The arial guard has no way to fix it, to the camera mount . I think this frame will find its way in the bin

I dont like the design , the blade guards are only supported by the 2,5 plastic stand offs in the middle ,and there is no way to support the outer edge of them The arial guard has no way to fix it, to the camera mount . I think this frame will find its way in the bin

I dont like the design , the blade guards are only supported by the 2,5 plastic stand offs in the middle ,and there is no way to support the outer edge of them The arial guard has no way to fix it, to the camera mount . I think this frame will find its way in the bin