Dani não tenho certeza se na minha acompanha! Vou verificar !

Mrmartinc 50.94*27.88*11.93MM

Gabbro These IS "dual-color" LEDs

Karavs Chip needs two voltage, one for logic supply and another for drive supply. From data sheets I found that max voltage for logic is 7 v and for drive - 50 v. This is parameters for chip. On board I see 12 v and 5 v supply inputs, where you found 5v-35v? 12 v is for drive supply (chip input 4) and 5v is for logic support (chip input 9)

bice90 Hi! In this case, you can do a little research, but TLDR: you can go up to 35 V, no problems, but you have to remove the jumper located above the power supply connector. Longer answer: 1st, you can see that the capacitors are rated for 35V (220 35V VT). Also, you can check the datasheet of the L298N chip which says that the maximum supply voltage is 46 V (page 3 of the datasheet). You have to be aware that there is a jumper on the board which should be removed if you use the device with larger than 12 V. The jumper is located between the input terminal and one of the capacitors (bottom left corner of the board). I also tested this type of circuit board with different voltages and it was fine. In fact, my board does not have the 12 V printed on it.