banjobang
banjobang when you use ELRS there could be some problems entring in config mode if you are using low speed rate (i.e. 50 Hz) or - and swiitch mode are settled in low resolution. Try to set your elrs communication mode in 100Hz (or more) and switch mode in full res 16ch rate ÷2 (via luav3 on the trasmitter) then try again
2025-07-19 07:51:16 Helpful (0)
banjobang no output is pal or ntsc
2025-07-19 07:42:54 Helpful (0)Q: What would be optimal C rating for this model's battery?
Asked by BG440654231 on 2025-05-15 06:30:06
banjobang draws 30 amp maximum. So 18650 3s2p it is enought or lipo 3s 3000 15C is ok
2025-05-20 03:19:47 Helpful (0)Q: How to connect ELRS receivier with RX and TX pins?
Asked by wain01 on 2024-03-10 04:05:21
banjobang in the middle row pins on the left side (opposite the servos pins) In order: black = G red = V white = T (elrs tx) white = R (elrs rx) then choose CRSF in the TELE menù worsk ok for me
2025-05-20 03:17:47 Helpful (0)
Q: Is blheli firmware upgradable?
Asked by banjobang on 2022-10-31 12:34:00
MPydigadu don't know
2023-01-27 10:50:22 Helpful (0)Q: hi, why to choose expresslrs in 2.4 ghz other 900 mhz?
Asked by Jonathan on 2021-11-19 09:08:47
banjobang 2.4 GHz Is shorter in range and subject to obstacle too. 868 - 900 is less subject to obstacle (i.e. trees, Buildings, etc.). Problem with 868 - 900 of you travel, some countries are 900 MHz legal (i.e. usa) other 868 (i.e. Europe). so if you travel often, Better 2.4GHz but of you Need consistent links Better 868 or 900.
2022-10-28 08:06:46 Helpful (1)Q: how do you change the language in the osd?
Asked by JimmyD1to3 on 2022-05-01 04:54:06
banjobang You Need an fpv and RC active connections to the controller. then wear googles or look at the monitor then fast toggle mode switch. Menu appears. Move cursore up down using elevator Stick, there are several Pages, so to go Next Page you have to go down again when on last menu item to go to the Next Page (language selevtion Is on the last Page). move ail Stick right to select menu voice then elevator to change. then ail left to exit item and then left to exit and save. only available languages are eng and chinese
2022-10-24 06:48:40 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
