BG511122141
BG511122141 Ithink 8.3 amp for a psu would be too low considering a standard 24v is usually 15 amps. I have a 24v 20Amp psu for one hotend and heated bed.
2021-08-12 09:15:42 Helpful (0)Q: can this kit be upgraded with an all-metal hotend and dual gear setup?
Asked by DragonDK on 2021-08-11 03:26:24
BG511122141 Ihave an all metal hotend mounted on the one I bought. I mainly only used the mounting plate. The extruder only mounts to the plate with two bolts so if your dual gear is similar to the one gear lever type I would say yes it will fit
2021-08-12 09:11:33 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
