aMax52
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
aMax52 NO, this is a downgrade to these cheap 722 chips. Not enough flash for PX4.
Helpful (0)
Q: will it be neccessary to do the taranis Q7 mode like on crossfire to get it work on 400k ? thx
Asked by MichalLucansky on 2020-08-09 01:04:38
aMax52 Not if you have the older ones of the first and... (second jQuery111309833756768419208_1597425085867? ) batch...the transmitter with the Ufl antenna........
Helpful (0)
Q: What is output voltage? 12V / 5V ??
Asked by VIP5 on 2020-03-19 14:01:18
aMax52 Since this no voltage module, that transfers input voltage to a different output voltage, its output depends on your input. But as a filter module, it works really nice. I have one of these attached to the dirty vbat output from the esc on my MinWing and no interference on the video even at full throttle......
Helpful (0)
aMax52 It works on path through. Works with Yaapu telemetry script on a pixhaw.You need at least APM3.4.0 for frsky path through which is not availablefor older boards.
Helpful (0)
Q: Compatible this receiver with FrSky DHT 8ch DIY transmitter module? Which cannel(PIN) is PPM output?
Asked by tolikas123 on 2019-12-25 07:28:52
aMax52 NO.With jumper firmware D16 only. (sbus/pwm)...no PPM. Telemetry only rssi if you don´t use a Pixhawk flight controller.
Helpful (1)
aMax52 For Inav 2.3.3, use /OMNIBUSF4V3_S5S6_SS target for this FC, Final I testet this and it works.Correct adc and an extra softserial port.
Helpful (0)
aMax52 Why not? Only a suitable cable is necessary ( or soldering)
Helpful (0)
aMax52 If not, useless for EU.
Helpful (4)