AggelikiVourtsi
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
AggelikiVourtsi yes you can set the power low so that the rubber won't melt but only burn to the logo you like
Helpful (0)
Q: Where does one get the operating software (Laser GRBL, etc.)
Asked by Gryphon on 2020-09-22 10:25:27
AggelikiVourtsi all free programs are OK but if you want to make a difference buy or use for free trial Lightburn . it is the perfect program for laser engraver
Helpful (0)
AggelikiVourtsi you can cut 3mm mdf either by using air assist and 6 passes with parameters 100% power and 100 speed OR 27 passes without air assist
Helpful (0)
AggelikiVourtsi The Grbl software opens only gcode files. Make sure your files are gcode files. Otherwise you can generate gcode from your svg files by using easel. Its an online program. Easy to use and free. Needs only to log in or register
Helpful (0)
Q: is this is okey to use in welding?
Asked by BG221164924 on 2021-01-23 10:06:54
Aggeliki Vourtsi NO WAY!!!!
Helpful (1)
Q: Is it safe for 5000mW laser (450nm)?
Asked by hgabor47 on 2021-01-15 01:04:52
Aggeliki Vourtsi yes
Helpful (0)
Aggeliki Vourtsi you better tighten the screws. it's not supposed to wobbles or moves up and down especially while engraving. it loses focusing
Helpful (1)
AggelikiVourtsi works for all laser engraver
Helpful (0)