faustor71Scritto 3056 giorni primaThe transistor tester and its case are excellent products and once everything is properly assembled it really looks like a professional tool! A few words about the case - the build quality is excellent and it all fits together snugly, however there may be some challenges in fitting the PCB kit + screen into the case and I would like to give a few tips on how I tackled them: 1) as many have pointed out, don\'t solder the green ZIF socket onto the PCB because it won\'t fit into the case and will be a pain to remove once installed; 2) for the external connectors assembly I soldered together pins 1-1 and 3-3 on the back of the connector, then cross-connected them to the external red & black probe connectors (the leftmost pin -(1) and the rightmost pin -(3) via short wires (blue & yellow); 3) then I connected the center pins 1-2-3 via short wires again (yellow-green-blue) and soldered them onto the TP1-TP2-TP3 pins onto the PCB; 4) for the 9V battery I found the supplied cable a bit too long so I first looped it a
Con Cyberbest05/04/2016This case is nice but it don’t seem to be manufactured for this component tester. It has many drawbacks. But with a little work is can work great. The first thing I noticed was there wasn’t any output for the function generator. Then the counter needed to have some strange arrangements of pin2 and 3 of the connector. Not to mention the connector is very low quality and won’t last very long with use. The two holes for the banana plugs is much larger than the plugs provided and so makes it
Con mitasat03/10/2017la cover si adatta perfettamente al circuito, ma bisognerebbe apportare delle modifiche alla scocca, come ho fatto.
1) inserire un terzo polo centrale per poter collegare anche il pin 2
2) inserire nel kit una femmina jack 3.5mm per poter collegare l' ingresso "F in"
3) inserire nel kit una clip per pila 9v