Tüm Mesajlar

Zeitauskaufer Yes, there is a link to the pdf manual in the offer directly above the order options. It takes about an hour to assemble. Don't forget the CR2032 button cell, otherwise all the effort would be in vain and in three years I will disassemble everything and replace the cell, but it is a beautiful part.

2021-11-11 04:57:51 Yararlı (2)
Gönder
cevaplar (1)

Zeitauskaufer Ifit is difficult to read the digits during the day, then it makes sense to switch off the automatic brightness control. However, depending on the choice of animation, you have an 8s long light show every full hour, which could worry the pets, who could then make noise. It would be better if the ratio of the darkening could be set in the setup 0 = brightness control off, i.e. always full brightness up to position 9 = maximum effect of the photo resistor. But that can only be fixed with a firmware update.

Riccardo Baseggio 06/10/2021
0
Yorumlar (1)
Zeitauskaufer 09/11/2021
0
Tavsiyeler
Yorumlar (0)

m1kes If you mean you want to use this in “jog/momentary” mode, then YES, you can do that by removing the jumper cap from the jumper pins on the receiver. In jog/momentary mode, each relay is only engaged while you push and hold the corresponding button on the remote fob. Releasing the button disengages the relay.

2018-06-08 04:04:24 Yararlı (1)
Gönder
cevaplar (2)