Alla meddelanden

Q: does it work with FlySky I6?

frågade av silviobraendle på 2019-11-06 09:39:39

efrancois Testedwith a Taranis QX7 only

2022-07-04 12:21:12 Hjälpsam (0)
Lämna
svar (2)

Q: does it fit M8*0.5mm lens thread?

frågade av silviobraendle på 2019-10-26 03:14:59

BG145716125 all ok

2022-02-26 04:16:22 Hjälpsam (0)
Lämna
svar (3)

HamsterHybrid Wennthe module is in "SET" mode, you can't send and receive commands, because the module awaits your settings via Serial. There is no need to constantly have the SET pin grounded, usually you set the module's settings once and that's it.

2021-10-29 05:56:59 Hjälpsam (0)
Lämna
svar (2)

Q: does the bottom conduct?

frågade av silviobraendle på 2019-11-10 07:02:03

Henrik NO! The adhesive does NOT conduct. You might get an (unreliable) contact at the edge of the tape, but NOT through the adhesive.

2021-10-25 03:36:24 Hjälpsam (0)
Lämna
svar (2)

JT_Enliten You may use the Uart pins for the two Arduino boards to connect each other, but you also need to wire their GND pins together.

2021-09-19 02:14:44 Hjälpsam (0)
Lämna
svar (2)

The seller Here https://www.banggood.com/30_5x30_5mm-MAMBA-F405-MK2-3-6S-Flight-Controller-compatible-DJI-FPV-Air-Unit-for-RC-Drone-FPV-Racing-p-1855166.html?cur_warehouse=CN

2021-06-03 06:08:29 Hjälpsam (0)
Lämna
svar (1)