These servos perform very well. Centering is good and they are strong. The best thing about these servos is every gear is metal unlike most "metal" gear servos where the 1st gear is plastic. The wire from the servo to the end of the plug is 260 mm's. In the box comes with a nice selection of arms and 2 little tabs that allow the servo to be mounted sideways.

These servos perform very well. Centering is good and they are strong. The best thing about these servos is every gear is metal unlike most "metal" gear servos where the 1st gear is plastic. The wire from the servo to the end of the plug is 260 mm's. In the box comes with a nice selection of arms and 2 little tabs that allow the servo to be mounted sideways.

These servos perform very well. Centering is good and they are strong. The best thing about these servos is every gear is metal unlike most "metal" gear servos where the 1st gear is plastic. The wire from the servo to the end of the plug is 260 mm's. In the box comes with a nice selection of arms and 2 little tabs that allow the servo to be mounted sideways.

Я купил, чтобы поместиться в моем v950 вертолет, но это немного большой 🤬 я найду для него применение где-то 👍👍

I bought to fit in my v950 helicopter but it's a little bit big 🤬 I will find a use for it somewhere 👍👍

Я купил, чтобы поместиться в моем v950 вертолет, но это немного большой 🤬 я найду для него применение где-то 👍👍

Good quality servo no loose on the bearings all gears are metal

Good quality servo no loose on the bearings all gears are metal

Good quality servo no loose on the bearings all gears are metal

хорошие

хорошие

хорошие

I used the mini servos as aileron expediters. The ES3302 provide a bit more torque than most minis (2.4Kg) which gives the ailerons the additional "oomph" , and thy do the job very well.

I used the mini servos as aileron expediters. The ES3302 provide a bit more torque than most minis (2.4Kg) which gives the ailerons the additional "oomph" , and thy do the job very well.

I used the mini servos as aileron expediters. The ES3302 provide a bit more torque than most minis (2.4Kg) which gives the ailerons the additional "oomph" , and thy do the job very well.

Fast delivery... working:)

Fast delivery... working:)

Fast delivery... working:)

I'm using 2 of this servo on ailerons in my 2.65m thermal glider with construction wing, AUW 1.3Kg, BEC setup to 5.5V Approximately 10 hours in total usage within 3 months, in the middle of 45 minutes long thermic flight, one aileron servo stock in the most upper position without any previous warning. I always do the short preflight check. The plane has no accidents or hard landings yet, just the scratches on covering foil. It was not so easy to land safely even with thermal glider in such a situation, but I have big luck and landing was 100% safely using one aileron, rudder and elevator. Today I dismounted servo to analyse problem, gears are 100% OK including the second one plastic in the chain, potentiometer was OK, but motor drains lot of current and was almost stock in one position, my USB powerbank self powering off because of this. So it looks like burnout motor winding.

I'm using 2 of this servo on ailerons in my 2.65m thermal glider with construction wing, AUW 1.3Kg, BEC setup to 5.5V Approximately 10 hours in total usage within 3 months, in the middle of 45 minutes long thermic flight, one aileron servo stock in the most upper position without any previous warning. I always do the short preflight check. The plane has no accidents or hard landings yet, just the scratches on covering foil. It was not so easy to land safely even with thermal glider in such a situation, but I have big luck and landing was 100% safely using one aileron, rudder and elevator. Today I dismounted servo to analyse problem, gears are 100% OK including the second one plastic in the chain, potentiometer was OK, but motor drains lot of current and was almost stock in one position, my USB powerbank self powering off because of this. So it looks like burnout motor winding.

I'm using 2 of this servo on ailerons in my 2.65m thermal glider with construction wing, AUW 1.3Kg, BEC setup to 5.5V Approximately 10 hours in total usage within 3 months, in the middle of 45 minutes long thermic flight, one aileron servo stock in the most upper position without any previous warning. I always do the short preflight check. The plane has no accidents or hard landings yet, just the scratches on covering foil. It was not so easy to land safely even with thermal glider in such a situation, but I have big luck and landing was 100% safely using one aileron, rudder and elevator. Today I dismounted servo to analyse problem, gears are 100% OK including the second one plastic in the chain, potentiometer was OK, but motor drains lot of current and was almost stock in one position, my USB powerbank self powering off because of this. So it looks like burnout motor winding.

The second set arrived in perfect condition, my initial problem was resolved immediately by Banggood so very happy, and I will buy more.

The second set arrived in perfect condition, my initial problem was resolved immediately by Banggood so very happy, and I will buy more.

The second set arrived in perfect condition, my initial problem was resolved immediately by Banggood so very happy, and I will buy more.

Bought 12 of these small ES 3302 servos with the aim of installing these in narrow wing mounts of small slope planes....received them in a timely fashion and have put all 12 through a servo tester. I'm mighty impressed by these servos , very clean and robust construction....really great number of horns(4) and one round disc....and speed / centering is absolutely perfect for an analog servo like this . So ....many thanks to Banggood.com to stock this range of quality servos....and also at a very competitive price !!!!

Bought 12 of these small ES 3302 servos with the aim of installing these in narrow wing mounts of small slope planes....received them in a timely fashion and have put all 12 through a servo tester. I'm mighty impressed by these servos , very clean and robust construction....really great number of horns(4) and one round disc....and speed / centering is absolutely perfect for an analog servo like this . So ....many thanks to Banggood.com to stock this range of quality servos....and also at a very competitive price !!!!

Bought 12 of these small ES 3302 servos with the aim of installing these in narrow wing mounts of small slope planes....received them in a timely fashion and have put all 12 through a servo tester. I'm mighty impressed by these servos , very clean and robust construction....really great number of horns(4) and one round disc....and speed / centering is absolutely perfect for an analog servo like this . So ....many thanks to Banggood.com to stock this range of quality servos....and also at a very competitive price !!!!

Всегда отличные сервоприводы

immer wieder tolle servos

Всегда отличные сервоприводы