Steve Davies
Q: If i buy this laser ? does it cut through a material?
Asked by dawtesdt on 2020-01-14 08:20:17
Steve Davies Yes,I cut .125" (3mm) plywood @350 mm,m with 4 passes with 1mm lowering per pass. I have also cut .25" luaun with 12 passes but very scorched edges.
2020-02-03 07:07:54 Helpful (0)
Steve Davies insideis pos. pinout from left to right( 2pin then 3pin) is (TTl,gnd)(PPM,gnd,pos)
2020-02-03 06:59:42 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
