Turbo_Raven
Q: Is it OK to make servo leads? (Futaba or JR type)
perguntado por Turbo_Raven sobre 2020-03-12 01:10:20
Quilling I think it can't
2020-03-16 04:06:19 Útil (0)
Thurloug Guffaw 3mm
2018-03-08 21:09:41 Útil (0)
Denshin diameter of the propeller pins is 3mm
2018-03-08 21:09:51 Útil (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
dfemmert The shaft is 3mm but there is no groove on the end of the shaft for the C-clip as shown in the photos. I bought it based on the photos but I won't be using it. I got it for a 34" 3D foamy and p... Ver mais
2024-04-01 15:10:35 Útil (1)