كل الرسائل

سؤال: what is the max temperature tht can be acheived from this product?

السؤال بواسطة andr00ahayes1967 على 2022-08-14 06:02:22

The seller Room temperature, 35 degrees higher than room temperature

2022-08-15 04:01:46 مساعدة (0)
عرض
أجابات (1)

سؤال: what is the distance of the mounting holes, centre to centre?

السؤال بواسطة andr00ahayes1967 على 2022-04-30 12:29:25

Sempiternal which mounting holes?

2022-05-09 02:11:56 مساعدة (0)
عرض
أجابات (1)

سؤال: what is the wire gauge?

السؤال بواسطة andr00ahayes1967 على 2022-03-02 04:00:41

BG181332314 It has 2 pins connector

2022-05-02 12:40:07 مساعدة (0)
عرض
أجابات (2)

سؤال: are they locking connectors?

السؤال بواسطة andr00ahayes1967 على 2021-08-16 09:46:11

ABDDWDSHA no

2022-01-25 02:16:42 مساعدة (0)
عرض
أجابات (2)
andr00ahayes1967 19/04/2021
When loading ProgISP+1.72 you are met with 2 kernel errors and the software is unusable in this state, after some searching around on the internet I discovered that renaming the file without any of the Chinese characters will solve the problem, the software does not include a BL Touch compatible firmware so you have to search on the Creality site for compatible software, as I had the 8-bit board I did not want a firmware above V1.6 as there are too many features enabled on these later versions which interfere with quality on detailed models, the software I chose had the z.y offsets set incorrectly, the nozzle when probing was in the position that the probe should have been and because Creality have not released the Marlin.INO file you can not edit the firmware to repair the error although later firmware versions enable you to so this, the z offset instructions in the Creality set up video does not give you a correct z offset and because they did not implement baby stepping you have to do this by increasing the z offset and printing a test first layer each time which was a pain, eventualy I did get the correct settings dialed in and it is working perfectly now, although the istaltion was a pain it was also educational, I reccomend this kit but also reccomend a n upgrade board, I have ordered the SKR E3 Mini V2, contact with Creality was poor, I used 8 differing methods to contact them and received one reply which was a pre written response to say if you bought it from anywhere other than Creality contact them
0
التوصيات
تعليقات (0)

سؤال: Can you also flash the bootloader with this kit?

السؤال بواسطة andr00ahayes1967 على 2021-02-08 06:24:45

Leon I was unable to get he included USB adapter to work with my Windows 10 laptop. Instead of pursuing it deeply, I upgraded to the 1.1.5 mainboard. This came with a bootloader and silent stepper drivers.

2021-02-08 11:33:21 مساعدة (1)
عرض
أجابات (2)