Mejores ofertas para Alfiler - Compras en línea Banggood Array

vyper1

mis contenidos: Todos los mensajes; Comentarios; Comentarios; respuestas; Preguntas

Todos los mensajes

vyper1 30/01/2019

I wouldn't say they are super loud but I can hear them clearly and that is all that's required.

5 PCS Súper Fuerte 5V Timbre de Alarma Activo Rastreador 9*5.5mm para Drones de Carreras RC MultiRotor FPV

4,60€ 8,29€

0

Comentarios (0)

vyper1 30/01/2019

Decent enough lipo checker to use at the field and at home for that quick status check. On occasion it's reading up to minus .03 V below the reading my charger or a multimeter gives but this is perfectly acceptable. Only thing I think this is missing, is a back light for low-light situations as the screen isn't the most visible.

3 en 1 2S-6S Descargador Probador de Voltaje Equilibrador para Baterías Li-Po Li-Fe

11,53€ 17,70€

1

Comentarios (0)

vyper1 30/01/2019

Good pins with a nice small 90 degree bend

10 Unids Lantian 2.54mm Dorado 3U Reversa Curvado Solo Encabezado de la Fila Pin Conector

1,53€ 2,86€

0

Comentarios (0)

vyper1 30/01/2019

This is my 1st quad so I have nothing to benchmark it against. I've done a few flights with it now and for me I think it's a fantastic quad. All I can say with 100% certainty are the things I don't like about this kit. I made the mistake of going to cut the motor wires to the exact length only to find out that it is the worst wire I have come across. Luckily I had only cut one of the wires before I realised not to cut them. There is absolutely minimal room within the frame to mount anything other than a micro RX and when you do fit this then make sure it's well isolated from the frame as it will induce unwanted vibration to the FC. I have installed anti vibration mounts for the FC as well as soft mounts for the motors just to make sure I don't get any erratic gyro behaviour. Even though this is my first quad I did find the camera to be a bad performer especially in low-light and transitioning from light to dark, so I swapped it out for a Foxeer Monster V3. I have managed to squeeze in a buzzer just behind the stack and I have replaced the antenna for a stubby one which is performing just as well as the long one that came with the kit. I have also managed to fit Leds around the quad which helps greatly when I fly LOS, so I would now say this kit is complete. Like I said, this is my 1st quad so I have nothing to compare its performance against but for me I find it a great first timer and it should help me learn at a reasonable cost.

Eachine Tyro99 210mm versión de bricolaje de carreras de drones FPV F4 OSD 30A BLHeli_S 48CH 200mW VTX Cámara 700TVL

123,61€ 148,52€

0

Comentarios (1)

vyper1 30/01/2019

Good little battery indicator and the fact you can set it for multiple voltages is a real bonus. So I have ordered a couple more for some more projects I'm doing. No instructions but you can figure out how it goes together, I'd suggest you install the bar display before you do the IC otherwise you can't have it flush.

Módulo de indicador de capacidad de batería LM3914, probador de nivel de potencia con pantalla LED

1,26€ 7,88€

0

Comentarios (1)

vyper1 30/01/2019

Simple motor controller, works perfectly well.

Mini DC 4.5V a DC 35V 5A 90W DC motor PWM Regulador de velocidad Módulo regulador de velocidad Regulador ajustable

2,23€ 3,31€

0

Comentarios (0)

vyper1 29/12/2018

seems to be decent enough quality and will come in handy.

Profesional Herramienta de Plantilla de Angulo Herramienta de Medición de Angulo Regla de Multi-Angulo del Transportador Regla de Herramienta de Diseño

4,50€ 18,09€

0

Comentarios (0)

vyper1 25/12/2018

Markings are off at the start of the ruler but other than that, they are fine.

1 pieza de regla recta de acero inoxidable de doble cara para medir de 15 cm en sistema métrico en color plateado

7,37€ 9,22€

0

Comentarios (1)

vyper1 25/12/2018

Used these to bind RX from TX module pins

Clip de Prueba de Gancho de Alambre para Analizador Lógico

6,45€ 8,29€

0

Comentarios (0)

vyper1 19/12/2018

Not used it yet but I can't see there being any problems. Seems to be a decent amount of windings so should last a while.

Alambre de Soldadura de Estaño de 0.5mm 63/37 Soldadura de Núcleo de Rosin 2% Tubo de Carrete de Flujo

2,66€ 2,91€

0

Comentarios (0)

vyper1 19/12/2018

Slight issue with the fact that the ruler doesn't start at 0. The 1st mark is about 1.5mm in size. Once you take that into consideration then you'll make no mistakes. They come in individual sleeves which is a bonus.

1 pieza de regla recta de acero inoxidable de doble cara para medir de 15 cm en sistema métrico en color plateado

7,37€ 9,22€

0

Comentarios (1)

vyper1 18/12/2018

Not put them to test yet but all cells balanced and they seem to be in good order. Hopefully they work as expected.

Batería Lipo ZOP Power 11.1V 1500mAh 40C 3S con conector XT60 para Eachine Wizard X220 FPV Racing RC Drone

15,62€ 24,90€

0

Comentarios (0)

vyper1 18/12/2018

I've built 5 of these and all have worked perfectly. My only gripe is they switched the power button and I'd prefer if these were micro usb powered instead of the barrel.

Kit de árbol de Navidad LED Flash de Geekcreit®, kit de aprendizaje electrónico en 3D para hacerlo tú mismo

3,68€ 12,91€

0

Comentarios (0)

vyper1 18/12/2018

Only time will tell to see how long they last.

DANIU Alicates eléctricos de corte de alambre Cortador de cables Alicates de punta Cizallas Laterales Herramienta

9,22€ 11,98€

0

Comentarios (0)

vyper1 18/12/2018

but does not work, red leds remain very dull and the aren't much better. There is no flashing so i think there's an issue with the IC

Geekcreit® Efecto de Estrella DIY 3D LED Kit Decorativo de Árbol de la Navidad

5,53€ 7,37€

0

Comentarios (0)

vyper1 18/12/2018

USB boards, perfect for my build.

5pcs Micro USB a hembra dip socket tipo B micrófono 5P Patch a Dip 2.54mm Pin con placa adaptadora de soldadura

2,77€ 7,37€

0

Comentarios (0)

vyper1 18/12/2018

It cleans your tip.

1PC Limpiador de punta de soldador de hierro pesado de alambre de acero Suministros de soldadura

8,29€ 13,83€

0

Comentarios (0)

vyper1 18/12/2018

It solders things together.

50 g 0,5/0,6/0,8/1,0 mm 63/37 FLUJO 2,0 % 45 pies Estaño Plomo Estaño Alambre Núcleo de colofonia fundido Soldadura Soldadura Alambre Rollo

4,61€ 10,14€

0

Comentarios (0)

vyper1 17/12/2018

Used mainly for sticking down Frsky RX to quadcopter and it does the trick.

Fuerte Permanente Rollo de 3 Metros Súper Adhesiva Cinta de Doble Cara para Vehículo

4,60€ 5,53€

0

Comentarios (0)

vyper1 16/12/2018

To start with, I have large hands but this form factor suits me ok and I don't have any issues with its smaller size. The buttons for open tx menu navigation are a bit unintuitive but after a while you get used to it. The gimbals seem fine and precise enough and the only thing this transmitter is missing is a momentary switch but overall it is a good TX and worth the money. My only true gripe is the bind process for some of the protocols you only get 2 or 3 bind chirps and dependent on the RX you are binding too,especially if it's one you have to start bind on TX then hold button on RX as applying power to it, then sometimes 2 or 3 bind chirps is not enough time. If this can be increased then please let me know. I'm also struggling to find a 2S lipo that will fit the battery compartment as this TX will eat through AA and NiMH in no time. But, overall I'm pleased with this Jumper T12 and only time will tell to see if it will stand the test of time.

Jumper T12 OpenTX 16CH Radio Transmisor con módulo de RF multiprotocolo JP4-in-1 para Frsky JR Flysky

84,68€ 97,43€

0

Comentarios (0)