Todas as mensagens

Q: Is this a 12mm lens? Can it be used on RunCam Split mini v2 instead of the m8 lens?

perguntado por 2013beyondreality sobre 2019-09-18 09:31:12

schuarch Yes, you can use it with the split mini v2 board.

2022-03-05 01:37:53 Útil (0)
Enviar
respostas (1)

Q: What is RT6 pad for?

perguntado por BG517811103 sobre 2021-12-17 09:05:58

schuarch This pad can be configured as soft serial in betaflight, either as RX or TX. Just use the “resource” command in the cli to check to which pin it is connected.

2022-03-05 01:36:49 Útil (0)
Enviar
respostas (1)

Q: Hi there, is this really only 4S? or maybe possible for 3S? - Thank you

perguntado por BG372161722 sobre 2022-03-05 07:54:23

schuarch I used it for 2S, 3S & 4S and it’s working fine at all that voltages. It’s a great flight controller.

2022-03-05 01:32:08 Útil (2)
Enviar
respostas (2)

Q: I have a fat shark scout & flysky FX-i6 X, compatible?

perguntado por BG341224473 sobre 2021-07-17 02:09:21

schuarch FrSky D8 built-in, you could add a FlySky receiver. But get the Version 2, has better VTX and camera (camera on this version is crap).

2021-07-17 03:22:36 Útil (0)
Enviar
respostas (1)

schuarch You can bind it to your radio, but not with the crossfire protocol but with FrSky D8 protocol via the internal multi protocol module of your radio. The range will be poor, however. You can also upgrade the Tinyhawk with a TBS crossfire nano receiver, then you can bind it to your crossfire module. This will require some soldering work, but you will start to solder anyway when advancing in this great hobby.

2021-02-10 05:53:09 Útil (1)
Enviar
respostas (1)

schuarch OK...It’s an amazing digital camera and transmission system for remotely flying FPV drones in beautiful HD quality (FPV = first person view). You also need the DJI FPV goggles for the system to work. It’s one of the most stunning things available for RC hobbyists!

2021-02-10 05:45:44 Útil (1)
Enviar
respostas (2)

Q: How to connect to individual 4 ESC, not 4in1 ESC ???

perguntado por igorsldk sobre 2021-01-27 01:18:39

schuarch You can run the signal wires from the 4-in-1 ESC plug on the board to the individual ESCs and supply them with VBat via an extra PDB. For a more elegant solution, look for an AIO board with integrated PDB.

2021-02-10 11:20:42 Útil (2)
Enviar
respostas (3)