Szczypior
D: black and red wires on rear camera what is it for ?
Domandata da sergzadoroz il 2017-11-29 07:05:57
Szczypior It's for powering it. There is separate connection of the circuit required in order to rear camera to work.
2023-04-24 03:44:49 Utile (0)D: does it come with the transmitter
Domandata da BG403745454 il 2023-04-24 06:44:32
Szczypior This is reciever only. Transmitter has to be bought separately
2023-04-24 03:44:37 Utile (0)
Szczypior Yes, it supports all common frequencies of analog transmission
2023-04-19 02:35:55 Utile (0)
D: hey does it come with everything needed to run controller ect
Domandata da rcmad94 il 2020-10-31 02:51:16
Szczypior This is a KIT version, so basically a plastic model without any electronics. mine came with a motor, but no ESC or receiver.
2020-11-01 12:43:26 Utile (0)D: Is this in stock? Do I need a special antenna for this?
Domandata da Sarbjit Billing il 2020-06-03 06:50:49
Szczypior It comes with no antenna so you need to order them separately. It uses SMA connector. Of course it's 2,4GHz reciever.
2020-06-03 06:54:01 Utile (0)D: can i use 3s 2200mah 11.1v lipojQuery111305403163780715163_1590404824781?
Domandata da BG264711952 il 2020-05-25 06:13:51
Szczypior yes, it supports 3-6S
2020-05-25 06:21:45 Utile (1)D: Other than the price, why would I choose this one than the new Jumber versions?
Domandata da jAm il 2020-04-26 04:11:29
Szczypior The communication in group is terrible. Bad comments are deleted, so Helikido is actually not right and delusional.
2020-05-21 12:11:12 Utile (0)D: FURYF4OSD (Legacy) or (Diatone)?
Domandata da dariuszkazmierczak8 il 2020-05-16 02:04:16
Szczypior Diatone site states it's legacy.
2020-05-16 02:16:44 Utile (0)D: Is the thread straight through?
Domandata da Sarel MVenter il 2019-09-02 06:22:21
Szczypior In my case it was.
2020-04-04 02:39:00 Utile (0)D: What kind of led does it support ? Only Mamba led or any WS2812 would works ?
Domandata da gabrielforray il 2020-04-04 08:31:51
Szczypior Any kind of LEDs, but keep in mind that 5V regulator has limited amperage. If you are willing to use some high power LEDs then you just take signal pad from FC and power up LEDs from other source. Of course this FC is not dedicated to any kind of LEDs manufacturer.
2020-04-04 02:38:17 Utile (0)D: Will the Pin of Battery Fit with Nano Fpv Camera Pin??
Domandata da adityash840 il 2018-06-15 07:19:08
Szczypior Very unlikely as this is PH2.0 and cameras use smaller plugs in most cases.
2020-03-27 05:00:38 Utile (0)Ti invitiamo sinceramente a iscriverti all'e-mail di risposta all'invito!
Se ti iscrivi, ti inviteremo via e-mail a rispondere alle domande che le persone hanno sui prodotti. Iscrivendoti] guadagnerai anche il "Badge utile "! Puoi annullare l'iscrizione in qualsiasi momento nella pagina delle impostazioni sulla privacy.
Aiuta gli altri e sii più felice!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Szczypior There are alternatives on the BG with similar AWG
2023-04-24 03:46:39 Utile (0)