pieter_van_durme
Q: Is it correct that the reduction ratio is indeed NOT 1:71 If so, is this seller trustworthy?
zeptal se pieter_van_durme na 2020-05-22 04:31:50
Spidery yes. Our mistakes have been corrected.
2020-06-01 01:17:50 Ochotný (0)
Q: any pin out diagram or pcb footprint for this?
zeptal se john.yan1019 na 2019-10-21 07:23:57
pieter_van_durme one side , one side - pins are easely mountable on pcb or breadboard
2019-10-30 11:03:34 Ochotný (1)Q: what is the frequency of these. I need to set my TX/RX
zeptal se spider na 2019-09-17 10:19:48
pieter_van_durme theseare dc motors. the times you can put it in the wall, and pull it out again would give you the frequency .
2019-10-30 11:03:05 Ochotný (0)
pieter_van_durme thereis a pinout for coolent and for a spindle motor. (you wil need additional relais offcourse) i must ad that this board had a serious design issue. it is wired the wrong way, what makes it unusable right out the box. tweeking is possible to make it work. I do NOT reccoment this board!
2019-10-30 11:00:49 Ochotný (0)Upřímně vás zveme k odběru e-mailu s odpovědí na pozvání!
Pokud se přihlásíte k odběru, pozveme vás e-mailem k zodpovězení otázek, které mají lidé ohledně produktů. Tím, že se přihlásíte k odběru, získáte také "Užitečný odznak "! Odběr můžete kdykoli zrušit na stránce nastavení ochrany osobních údajů.
Pomozte ostatním a buďte šťastnější!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
