Najlepsze oferty dla Szary konwój S2+ SST40 1800lm Latarka 18650,Ładowarka,Kamera bezpieczeństwa - Banggood Array Zakupy online

nullvoxel

moje treści: Wszystkie wiadomości; Opinie; Komentarze; odpowiedzi; pytania

Wszystkie wiadomości

nullvoxel 27/01/2021

awesome torch. gets warm but not hot enough to cause damage to led or make it uncomfortable to hold. careful to not put it down when running, as the light output can burn things from this torch.

Gray Convoy S2+ SST40 1800lm 5000K 6500K Ochrona przed temperaturą Zarządzanie latarką 18650

20,01€ 25,82€

1

Komentarze (0)

nullvoxel Isn'tthe output isolated already?

Jarrodduval 11/05/2020

Arrived with red positive wire disconnected . Re soldered and hot glued.. Really needs better terminal protective wrapping. Pretty much nothing except a nylon sticky wrap. Which really doesn't offer much protection. I suggest you buy kapton tape, and some really high quality electrical tape. Better safe than dead, internally these power supplies store a lot of charge NO JOKE. Finally I wrapped it in car vinyl wrap as the outside casing is earthed. Not saying these are not worth buying . Just be prepared to make it safer to use as a power supply for lipo battery charging. Below are some pictures of the final result. Thankyou

HP Zasilacz DC 12V 460W 38A z wtyczką XT60U-F dla ISDT Q6 Ładowarka akumulatorów SKYRC B6 NANO

29,51€ 35,97€

7

Komentarze (1)

Kamera 1080P ładowarka bezprzewodowa ładowarka mini USB kamera wykrywanie ruchu 1A szybkie ładowanie kamera bezpieczeństwa przenośna kamera zasilacz wideorejestrator

23,05€ 24,90€

Q: does this camera work all the time.. recording full time . or just when it detects movement.?

zapytał BG401817433 na 2021-06-01 07:21:20

nullvoxel both. Move the switch from "L" (loop recording) to "M" (Motion recording) to change between modes.

2021-06-01 08:30:31 Pomocny (2)

Zatwierdź

odpowiedzi (1)

nullvoxel 10/02/2021

Seems to work well. time will tell if it balances the batteries.

3S BMS 25A 12,6V 4S 16,8V 5S 21V 18650 Li-ion Płytka ochrony baterii litowej Polimerowej Lipo ogniw PCB obwodu ładowania modułu PCM

1,84€ 9,22€

0

Komentarze (1)

nullvoxel 10/02/2021

everything works as described. I would say it can do more then it's rated thickness as it was welding very well at it's rated thickness at power level 3. The USB-C versions charge port is a bit finicky.

1S Mini Spawarka do spawania punktowego na baterii litowo-jonowej 18650 Przenośna spawarka do spawania taśmową niklu w gospodarstwie domowym

48,36€ 63,65€

0

Komentarze (1)

nullvoxel 10/02/2021

It's a fuse holder. I don't think anything needs explaining.

HS-912 Średni wodoodporny 16AWG Drut w linii Car Automotive Blade Fuse Holder

5,53€ 7,37€

0

Komentarze (0)

nullvoxel itdoes have an auto-detect mode. You enable it by first turning on the device and then single pressing the button.

psychotik2k3 11/07/2020

tested quickly on an AA battery, it worked. in reality the device send the current every 1.5 seconds with a beep, so it does not detect if you have contact or not (i have the mini usb version). but for the price it's cool. only 2 drawbacks are on the solder pins: it seems they are not removable and they are not isolated on a long distance, the distance where you hold it with your fingers... i'm not sure what happens if your fingers are wet... i isolate them with some thermalshrink tubes for safety.

1S Mini Spawarka do spawania punktowego na baterii litowo-jonowej 18650 Przenośna spawarka do spawania taśmową niklu w gospodarstwie domowym

48,36€ 63,65€

25

Komentarze (10)

nullvoxel 10/02/2021

Resistors work as expected. The value of them doesn't change when jolted so i would say the mechanical side of them is good. The screw has a nice firmness to it but not too firm.

Zestaw oporników regulacyjnych Geekcreit® 10 wartości 100szt. 100Ω~1MΩ

9,22€ 17,49€

0

Komentarze (0)

nullvoxel 10/02/2021

buttons work as expected. Great for replacements or prototyping.

100 sztuk 10 modeli 6x6 przełącznik taktyczny dotykowy przełącznik przyciskowy wysokość 4,3 mm-13 mm DIP 4P mikroprzełącznik 6x6 przełącznik kluczykowy

8,29€ 10,14€

0

Komentarze (0)

nullvoxel 10/02/2021

18V 2.5W Mini panel fotowoltaiczny z polikrystalicznego panelu słonecznego do samodzielnego montażu

7,37€ 11,06€

0

Komentarze (0)

nullvoxel 10/02/2021

Works well. Adjusted my 18V MPPT to 12.4v for a 3S battery so as to undercharge it for better life.

Regulator ładowania słonecznego MPPT 1A 3.2V 3.7V 3.8V 7.4V 11.1V 14.8V Moduł ładowarki akumulatorów litowo-jonowych LiFePO4 i Titanate SD30CRMA

6,45€ 12,91€

0

Komentarze (0)

nullvoxel 10/02/2021

5mm / 10mm / 15mm / 20mm / 25mm / 30mm wysokotemperaturowa taśma poliamidowa odporna na ciepło do drukarki 3D

4,60€ 5,53€

0

Komentarze (0)

nullvoxel 27/01/2021

powerful little torch. does get warm in the hand but not warm enough to cause damage to led or be uncomfortable. be careful of light output as it can burn things on maximum setting, so make sure to turn it off before you put it away or in pockets.

Konwój S2+ SST40 1800lm 6500K Ochrona temperaturowa latarki na baterię 18650

16,72€ 29,51€

0

Komentarze (0)

220V Absorber Dymu Lutowania Filtr Powietrza Odsysacz Spawania

31,37€ 52,58€

Q: does it work with 230V?

zapytał BlueNath na 2019-10-15 12:47:14

nullvoxel worksfine on my 240v supply

2021-01-27 12:29:40 Pomocny

Zatwierdź

odpowiedzi (2)

nullvoxel 06/08/2020

Works well for BGA jobs. Shame it doesn't come with a plunger though.

KSS S800 10CC Pasta lutownicza do dyspensowania SMD Bga na przewodach

12,20€ 14,75€

0

Komentarze (0)

nullvoxel 06/08/2020

Great for the price. but it's a little hard to dispense the liquid flux with it.

BON-102 Pasta fluksu Klej do lutowania, Przetwornik fluksu Pen

8,29€ 10,14€

0

Komentarze (0)

nullvoxel 06/08/2020

Good value good product works as described solder flows well but cleanup is a little harder then with most fluxes.

MECHANIK MCN-UV80 No-clean pasta lutownicza topnik lutownica BGA topnik do spawania elektrycznego do PCB BGA SMD

11,06€ 13,83€

0

Komentarze (0)

nullvoxel 30/06/2020

Fan is a bit loud Quality of plastic is okay for what it is. Don't expect anything super durable. Apart from that, no complaints. Does what it says on the tin.

220V Absorber Dymu Lutowania Filtr Powietrza Odsysacz Spawania

31,37€ 52,58€

0

Komentarze (0)