Vylepšený 3018 Pro CNC Router Offline Rytier DIY 3Axis GRBL Rytina Stroj Drevodom
Časť recenzie bola preložená automaticky.
I can confirm receipt to day. (The button [Confirm Receipt] is not visible, instead of this [Buy Again] is on this button. Avaiting again response of my question for the best / strongest possible laser for this machine. They are several lasers but without a compatibity remarked.
The machine frame is very solid, although it is made from metal and plastic parts. The linear rods are 10 mm in diameter, not 8 mm like the ones from 3D printers. It uses a custom made ATmega328p based control board running GRBL 0.9j. I like that it has an offline controller which allows me to load Gcode from SD card and keep my computer away from the CNC. In the product description, they say you should not upgrade to GRBL 1.1. I did that and the CNC works smoothly (I flashed the precompiled GRBL 1.1h using avrdude - the board has Arduino bootloader). After flashing new firmware, all settings need to be checked and set back to machine defaults (which you should get before updating firmware). By default, mine came with inverted Y axis (see the mirrored text on the red plywood). This can be fixed by sending $3=2 to GRBL (setting is saved in EEPROM and is stored even after power off). Another thing to mention is that you should double-check all screws, especially the ones from pre-assembled Z axis and spindle. My Z-axis lead screw slipped from motor axis, the spindle couldn't be lifted and I broke the bit. Spindle motor RPM is another unknown thing about these machines, and I'm thinking of measuring it. Last, use a grease spray and lubricate lead screws and linear rods. It is also important to keep these parts clean.