Minden üzenet

MoriXTV The wing is glued but the glue is very weak and doesn’t stick to the foam that hard so you can easily peel it of and glue it back in. I replaced the glue in the whole frame just to make sure it doesn’t fall apart at 220kph ;)

2019-07-30 06:28:58 Hasznos (0)
Beküldés
Válaszok (1)

Q: What's the "T" pads purpose? Test something?

Kérdezte marco tovább 2019-06-10 07:34:55

wujiahui “T” indicates that adding a normally closed temperature sensor switch can extend the temperature protection function, and the switch should remove the OR resistor next to the solder joint.

2019-06-11 08:34:26 Hasznos (0)
Beküldés
Válaszok (1)

marco Andwhy this should be an ESC fault? It's an opto esc and it's also written in the description "BEC (Linear): NO".

the_KHA 19/09/2018
2
Hozzászólások (3)

Q: Does it work with 16 Volt 4s? I Have had one at it got broken.

Kérdezte winowin tovább 2019-02-08 05:30:44

marco the connector is clearly for a 3S battery...

2019-02-10 11:49:47 Hasznos (0)
Beküldés
Válaszok (1)

marco Not in the kit, i agree that they should have at least highlighted that it will need a not-standard servo connector. Ayway, it's not an XT60 connector for sure. How did you manage to wire the servo cable? Mine came with already glued/never cut wire channel...

2019-01-28 03:25:29 Hasznos (0)
Beküldés
Válaszok (2)

marco Hanno il connettore "piccolo" adatto allo zohd dart da 635mm? Grazie.

Silvio 11/06/2018
1
Hozzászólások (1)