Alla meddelanden

catsndogs1965 Yes, no need for power plug just for checking voltage on the individually cells, but for charging you have to connect the power plug as well.

2021-08-08 11:24:32 Hjälpsam (4)
Lämna
svar (4)

sunny Suitable for 0.5-1.5 square wire, wire diameter 1.6-2.5mm

2022-08-08 04:18:00 Hjälpsam (0)
Lämna
svar (1)

Q: Does this model has a current sensor?

frågade av Den92 på 2020-04-13 02:12:46

NL_Hees No it does not have a current sensor. But on a small model like this voltage sensing is all you need in order to land in time (you are not going to sinking range flights with this)

2020-04-14 01:20:36 Hjälpsam (0)
Lämna
svar (1)
Den92 07/07/2018
It's a nice cheap FC but has some serious design flaws: 1) LED strip does NOT working out of the box. I've managed to fix it by soldering the jumper as shown on the picture (it was not easy to sold precisely on pin with 0.3mm pitch without enough practice...). Don't try to remap in BF the led strip to D2 (where it should be), because USB won't work until you reflash in DFU mode. 2) When connected to USB with no battery, voltage from USB is passing directly on battery input, so BF thinks there is 1S battery connected and beeps a continuous alarm which is very annoying... 3) There is a strong noise on 5V bus, can be seen when connect the camera to it. Just soldered a big ceramic or tantalum capacitor to fix it. 4) There is no cable included for esc outputs, I had to solder off the connector and put a tiny wires in place of it. In overall, it's a good value and performance for this price. I've replaced picoblx with it on my Kingkong fpv egg 136 and got a lot of nice features: 1) Integrated OSD, finally I can use more expensive camera with no built-in osd (like Caddx SDR). 2) PIDs and settings can be changed through osd menu, very nice feature. 3) Blackbox logging, 8Mb flash memory, enough for about 3 mins of logs. 4) Full DSHOT support It's a good tiny board, cheap and with a lot of features, but it lacks a lot of quality control. Some users have reported gyro and BEC issues, but luckily I didn't found any. I hope they will make the second revision of this board with these issues fixed.
0
rekommendationer
kommentarer (0)