すべてのメッセージ

Q: what are the benefits of each tail?

尋ねた Alian に 2022-02-23 01:12:34

Nincompoop The conventional layout of T-tail is more stable, and the structure of v-tail is simpler and more flexible.

2022-02-24 03:58:38 役に立つ (1)
提出
回答 (1)

Q: what is the size of the motors?

尋ねた Alian に 2020-04-15 03:13:44

BG204249554 little but they are still strong enough

2021-09-25 12:08:46 役に立つ (0)
提出
回答 (2)

Q: will this work with Eachine EO16H?

尋ねた Alian に 2021-06-08 06:04:42

Septimal Can not find Eachine EO16CH on BG Website, so can not make sure what procotol is it. iF8 support D8 / D16 v1 FCC / D16 v1 LBT / D16 v2 FCC / D16 v2 LBT (No Frsky ACCESS support) . You can check by yourself.

2021-06-11 04:55:49 役に立つ (0)
提出
回答 (1)

Q: will this fit 12428?

尋ねた Alian に 2021-03-28 12:58:09

Hoydenism No,you should buy this one drive shaft,product id is 1318141

2021-03-29 05:51:17 役に立つ (0)
提出
回答 (1)

Q: what drone is that?

尋ねた Alian に 2020-12-22 12:58:59

CutiePie not sure

2021-01-06 02:54:25 役に立つ (0)
提出
回答 (1)

Q: Will this fit the Caddx Vista?

尋ねた Alian に 2020-05-04 01:20:10

Winnit No, the Vista will not fit into this frame.

2020-05-05 09:01:11 役に立つ (0)
提出
回答 (1)

Povd It is just a piece of wire but that is typical with any whoop board with a built in reciever and I'm sure it has something to do with them being synonyms for having horrible reception, that being said the antenna dosen't need to be grounded to work correctly. When you run ground to a receiver wire it's to ground the shielding on that wire and then the actual signal wire runs through the shielding till it getd close to the end where its exposed and this exposed wire at the end is what actually dose the work cause its cut to a certain length to work with the particular frequency being used 2.4ghz in this case. As long as that wire is the same length as the wire that exposed from the shielding on a wire that's has to be grounded it essentially dose the same job. but it also has to be free from obstructions cuase that can dramatically reduce your range so this is where longer shielded wires that have to be grounded are preferred if weight isn't an issue because they move the signal wire farther away from the obstructions of the frame and other parts on a model

2020-01-17 02:30:08 役に立つ (1)
提出
回答 (1)