Need to enter set12c_highspeed=off in the CLI then save.

Need to enter set12c_highspeed=off in the CLI then save.

Need to enter set12c_highspeed=off in the CLI then save.

have it connected to my Naze32, now I can see all my values, very small but good readability, works like a charm

have it connected to my Naze32, now I can see all my values, very small but good readability, works like a charm

have it connected to my Naze32, now I can see all my values, very small but good readability, works like a charm

It works well with my Sp Racing f series. Nice.

It works well with my Sp Racing f series. Nice.

It works well with my Sp Racing f series. Nice.

Muito bom!

Muito bom!

Muito bom!

Für Naze Projekte

Für Naze Projekte

Für Naze Projekte

I will use at the future, trested in a pixhawk, very good

I will use at the future, trested in a pixhawk, very good

I will use at the future, trested in a pixhawk, very good

Tudo ok!

Tudo ok!

Tudo ok!

alles super gutes teil

alles super gutes teil

alles super gutes teil

Доставили быстро и то что заказывал.

Доставили быстро и то что заказывал.

Доставили быстро и то что заказывал.

i connected via I2C to the FC to show some sensor data. It's working but after some time the board kind of freezes and the red status LED is blinking. This happens when i power over Lipo And Also over USB. The Time When It "freezes" is changing, so sometimes it works and sometimes several minutes only a couple of seconds. When it freezes the Cleanflight CLI says the CPU is at 100% and the I2C error counter is at several thousand Errors. When I unplug and repower the board everything is working until I freezes again.

i connected via I2C to the FC to show some sensor data. It's working but after some time the board kind of freezes and the red status LED is blinking. This happens when i power over Lipo And Also over USB. The Time When It "freezes" is changing, so sometimes it works and sometimes several minutes only a couple of seconds. When it freezes the Cleanflight CLI says the CPU is at 100% and the I2C error counter is at several thousand Errors. When I unplug and repower the board everything is working until I freezes again.

i connected via I2C to the FC to show some sensor data. It's working but after some time the board kind of freezes and the red status LED is blinking. This happens when i power over Lipo And Also over USB. The Time When It "freezes" is changing, so sometimes it works and sometimes several minutes only a couple of seconds. When it freezes the Cleanflight CLI says the CPU is at 100% and the I2C error counter is at several thousand Errors. When I unplug and repower the board everything is working until I freezes again.