I have this unit currently running a custom built 21.5mm EDF with a Horizon BLH3327 8mm brushless tail motor at around 3A max. The throttle response is a bit stiff and LVC is hard, but it works. Also tested a 5320 1.7gm servo in the aileron channel, working fine. I soldered the motor wires directly. The unit came with both 1.25mm and 1.5mm connectors which could be soldered to the unit for the motor connection, as well as a short 3 wire motor harness with a 1.5mm connector attached, which was a nice plus. The unit has 2 pad sets for the motor connection, with 1.25mm and 1.5mm spacing, allowing for usage of either of the provided motor connectors.

I have this unit currently running a custom built 21.5mm EDF with a Horizon BLH3327 8mm brushless tail motor at around 3A max. The throttle response is a bit stiff and LVC is hard, but it works. Also tested a 5320 1.7gm servo in the aileron channel, working fine. I soldered the motor wires directly. The unit came with both 1.25mm and 1.5mm connectors which could be soldered to the unit for the motor connection, as well as a short 3 wire motor harness with a 1.5mm connector attached, which was a nice plus. The unit has 2 pad sets for the motor connection, with 1.25mm and 1.5mm spacing, allowing for usage of either of the provided motor connectors.

I have this unit currently running a custom built 21.5mm EDF with a Horizon BLH3327 8mm brushless tail motor at around 3A max. The throttle response is a bit stiff and LVC is hard, but it works. Also tested a 5320 1.7gm servo in the aileron channel, working fine. I soldered the motor wires directly. The unit came with both 1.25mm and 1.5mm connectors which could be soldered to the unit for the motor connection, as well as a short 3 wire motor harness with a 1.5mm connector attached, which was a nice plus. The unit has 2 pad sets for the motor connection, with 1.25mm and 1.5mm spacing, allowing for usage of either of the provided motor connectors.

Looks like a great little DSMX/2 reciver, but I have not started any soldering yet or tried it. Easy steps to get it to work. Hopefully, I will be in the air soon 🙂 Thank you, Bangood 👍

Looks like a great little DSMX/2 reciver, but I have not started any soldering yet or tried it. Easy steps to get it to work. Hopefully, I will be in the air soon 🙂 Thank you, Bangood 👍

Looks like a great little DSMX/2 reciver, but I have not started any soldering yet or tried it. Easy steps to get it to work. Hopefully, I will be in the air soon 🙂 Thank you, Bangood 👍

perfect :-)

perfect :-)

perfect :-)

Works as described. Easy to set up with the included qr code.

Works as described. Easy to set up with the included qr code.

Works as described. Easy to set up with the included qr code.

molto buono

molto buono

molto buono

after binding the motor still won't run

after binding the motor still won't run

after binding the motor still won't run

ok

ok

ok

Super klein und leicht probiert habe ich ihr noch nicht.

Super klein und leicht probiert habe ich ihr noch nicht.

Super klein und leicht probiert habe ich ihr noch nicht.

alles bestens

alles bestens

alles bestens

all ok

all ok

all ok