Anrein
Q: where to wire S.Port? (I wire my SBUS to RX6). I’m using R-XSR receiver
Asked by Anrein on 2018-07-01 11:52:21
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Franck_HELIE With betaflight, if you use sbus connected to rx6, you probably don't need ppm 1 pin. In this case, you can use softseral_tx on ppm 1. To do that, in btf cli, write following commands : activate Tele... See More
2019-01-17 15:57:32 Helpful (1)