All Messages

Q: Can i use 36 v psu for this ?

Asked by vallovirnas on 2020-05-22 04:00:45

Ernie DC24V 4A anything larger will probably burn up the control board,

2020-05-27 07:59:20 Helpful (0)
Submit
Answers (1)

Q: How would I install limit switches?

Asked by jwschull on 2020-05-20 06:02:28

Ernie I haven't installed limit switches yet but if you google this ( 3018 3 axis mini diy cnc router limit switches installation) there are a lot of youtube videos about it.

2020-05-20 08:09:08 Helpful (0)
Submit
Answers (5)

Q: What type of papellers does it take

Asked by BG314565537 on 2020-04-29 05:03:15

Ernie 8040or 9040 are what the page says. I have used 7060 and 8x4.3 props.

2020-05-06 12:52:54 Helpful (0)
Submit
Answers (1)

Q: May i know the diameter of the motor mount? Thank you!

Asked by Greg Bambie Demandante on 2020-04-29 03:14:58

Ernie The motor mount measures 1.25 inches across the face.

2020-04-29 08:23:15 Helpful (0)
Submit
Answers (3)

Q: What do I need Ali g with the machine to start ?

Asked by timmysanders2014 on 2020-04-13 02:50:14

Ernie Sorry I don't understand the question, But Erp's answer seems like a great place to start.

2020-04-13 11:56:18 Helpful (0)
Submit
Answers (2)
Ernie 2020-01-03 00:04:03
0
Recommendations
Comments (0)

Top reviewers you may like:

Ernie https://www.banggood.com/7Pcs-ER11-1-7mm-Spring-Collets-with-ER11A-5mm-Motor-Shaft-Holder-Extension-Rod-p-1209318.html?rmmds=myorder&cur_warehouse=CN

2020-04-03 05:46:52 Helpful (1)
Submit
Answers (3)

Ernie Itprobably can but BE WARNED cutting carbon fiber without proper safety equipment and ventilation is very unhealthy.

2020-04-03 05:37:59 Helpful (0)
Submit
Answers (1)