All Messages


2021-06-25 07:03:39 Helpful (0)
Answers (1)

Q: Can this machine be used to drill holes from a gerber file?

Asked by BG256245234 on 2020-06-14 04:17:46

jimbob6 yestotally. you could rout out the whole board if you wanted to (assuming 2 layers.) might need to get some different end mills and drills though.

2020-10-19 09:42:57 Helpful (0)
Answers (1)

Q: 200W so small very impossible

Asked by BearLionKing on 2020-07-06 03:14:07

jimbob6 The answer is in the rest of the spec 5.5v x 3A is 16.5W I think they meant to say 20W not 200W although 20 is still too high.

2020-08-07 11:52:53 Helpful (3)
Answers (3)

jimbob6 kinda its arduino based and port A0-7 is available so if the grbl firmware you are using has the interface hooked in there then you could get it to work. you might need to get a bit hacky with it though but if you are unsure about your abilities in this regard, bangood has a controller board that comes with an offline controller for only an extra $10.

2020-02-13 05:36:14 Helpful (0)
Answers (2)

Q: can it cut plexiglass 10mm thick?

Asked by LuKun on 2018-11-03 12:00:03

jimbob6 Ihave ran this for a while and it would easily do plexiglass, Its all about the feeds and depth of cut. you would probably want to get some upgraded end mills for it though the v-bit that it comes with is really only good for engraving.

2019-12-07 08:05:12 Helpful (0)
Answers (1)

Q: Could it work with 110v power?

Asked by PIGUAVE on 2018-09-15 09:50:25

jimbob6 Why does it have a 110v plug if it only works on 220v?

2018-09-18 08:07:11 Helpful (4)
Answers (14)