All Messages

Tjb4764 Camera model: Foxeer Falkor (Full size), Flight controller model: Airbot Omnibus F4 Fireworks v2 (OMNIBUSF4SW), Firmware version: Betaflight 3.5.1, Pad label: Camera Control, resource CAMERA_CONTROL 1 B09, camera_control_mode = default (HARDWARE_PWM), camera_control_ref_voltage = default, camera_control_key_delay = default, camera_control_internal_resistance = default, Additional comments: OSD pin camera -> camera control pad FC / GND pin -> GND FC, no additional caps or resistors needed

2018-09-27 03:58:28 Helpful (0)
Answers (1)

genivos There's one wire on the FC (blue) awful close connected to the top most ESC wire. That ESC power wire has a pretty big goop. Not sure if that caused a short, difficult to see on the pic .. it's just awful close.

nbtran1975 25/06/2018
Comments (2)