All Messages

Q: Hello, which glue is recommended?

Asked by BG471316201 on 2020-08-05 03:56:30

nikkor Google for UHU Por - that's the special glue that works well and should be available in your nearest home DIY store.

2020-08-05 06:00:58 Helpful (0)
Answers (4)

Q: Is it compatible with a sbus or would I need to use it as an Ibus?

Asked by BG184781557 on 2020-05-15 01:52:24

nikkor This receiver has i-BUS and S.BUS output as well as PPM. There are 4 wires on the module: - PPM signal (8 channels via 1 wire) - i-BUS and (or) S.BUS signal (18 channels via 1 wire) - VCC (this is power) -GND (this is ground) Hope it helps. Good luck with your project!

2020-05-15 04:36:05 Helpful (4)
Answers (5)

nikkor Please check the manual:

2020-04-21 05:10:19 Helpful (0)
Answers (1)

Q: what power cord do you use for 4s battery with xt60 con ?

Asked by mpsyes on 2020-02-05 07:43:16

nikkor You can use any cord with Male DC 5.5X 2.5mm at the end (facing solder iron). For example:

2020-02-06 05:24:53 Helpful (1)
Answers (2)