All Messages

dougkahn1959 I made a stand for the light using a 1 inch PVC pipe and a piece of 2x4 wood as a base. cut the wood the same dimension 4x4, then I drilled out a hole in the middle using a 1 inch paddle bit. Cut a piece of 1 inch PVC piping to 10 inches, then inserted PVC into wood and then inserted light into the PVC piping (18 inches total height), You can cut the PVC to any length just remember the higher you go with the PVC you increase the chance of light tipping over. I removed most of the foil off of the light to get a full 360 emission of the UV lightDoug

dougkahn1959 2020-05-11 10:50:56
0
Comments (1)