phil-le-b Ialready got 2x 750mah 4s r-lines which are 84g and now got 2x 650mah which is the same as yours 74g. It would be good to see how much flight time I get about 6 minutes from the 750mah Also have you tried the 850mah which is listed as 100g???

phil-le-b howare you finding the drone i just got one but its keep disconecting

phil-le-b whatprops have you used so far was thinking about 3s 650mah with 3018 props

phil-le-b on my printer i have been using the stocking setting which is 60.c for the bed and 200.c for the hot end maybe ill try 190 but tbh i have been getting very good prints

phil-le-b would you say its 3x times stronger then PLA because they say the ST-PLA is 3x times stronger jQuery19108048351943165182_1587506969673???

phil-le-b and me i had problem my vtx would turn off after 30sec due to the bec can only give 500mah which is not anuff to run a vtx and cam :( i had to use a 12v bec and wire that up