dpowellmeii The manual doesn't say anything about pushing the button. You need to do steps 5 and 6 and if you have upgraded to Betaflight version 4.0.0 and later you will have to downgrade to one of the version 3's to bind. 5.Receiver configuration Ports and receiver mode sets like the bellowing diagram: First Enable Seria_RX for uart3 and Set Receiver mode to “RX_SERIAL” , Select “Spektrum2048” signal for DSMX radio and “Spektrum1024” signal for DSM2 radio in Betaflight configurator . And the default channel map is “TAER1234”, please check your RC transmitter channel map, make sure they are matched, otherwise it will not armed. 6.Binding procedure (1) Connect BEECORE V2.0 DSM2/DSMX Version to computer and open Betaflight configurator, From CLI tab type: "set spektrum_sat_bind = 9" for DSMX radio or "set spektrum_sat_bind = 5" for DSM2 radio (2) Type "save" and after Flight controller reboot remove USB cable (=Power off the board) (3) Wait a second and reconnect the USB cable. After cold start the led combo(2 white color LED and 2 red color LED) should start blinking fast and transmitter should be turned on while pressing the bind button (4) After binding the led combo should be solid. Connect Betaflight and use receiver tab to test that receiver is working correctly. (5)

Helpful (0)
Answers (2)