정확한 세부 사항:
ì„ ì–¸
ìžë™ì°¨ ìš© ì „ìž ì†ë„ 컨트롤러 (ESC)입니다. RC 모ë¸ì˜ ê³ ì¶œë ¥ ì‹œìŠ¤í…œì€ ë§¤ìš° ìœ„í—˜í•˜ë¯€ë¡œì´ ì„¤ëª…ì„œë¥¼ì£¼ì˜ ê¹Šê²Œ ì½ìœ¼ì‹ì‹œì˜¤. 당사는 ì œí’ˆì˜ ì˜¬ë°”ë¥¸ 사용, 설치, ì‘ìš© ë˜ëŠ” ìœ ì§€ 관리를 í†µì œ í• ìˆ˜ 없으므로 ì œí’ˆ 사용으로 ì¸í•œ ì†í•´, ì†ì‹¤ ë˜ëŠ” ë¹„ìš©ì— ëŒ€í•´ ì±…ìž„ì„지지 않습니다. ìš´ì˜, ì˜¤ìž‘ë™ ë“±ìœ¼ë¡œ ì¸í•´ ë°œìƒí•˜ëŠ” ëª¨ë“ í´ë ˆìž„ì€ ê±°ë¶€ë©ë‹ˆë‹¤. 우리는 ê°œì¸ ìƒí•´, ì œí’ˆ ë˜ëŠ” ì œìž‘ ê¸°ìˆ ë¡œ ì¸í•œ ê²°ê³¼ì ì†í•´ì— 대해 ì–´ë– í•œ ì±…ìž„ë„지지 않습니다.
í’모
1. ë›°ì–´ë‚œ ì‹œë™, ê°€ì† ë° ì„ í˜•ì„± ê¸°ëŠ¥ì„ ê°–ì¶˜ RC 카를 위해 특별히 설계ë˜ì—ˆìŠµë‹ˆë‹¤.
2. Compatible with sensorless brushless motor.
3. ê°•í•œ ì €í•í•˜ëŠ” 현재 기능, 우수한 ì—´ 분산.
4. Multiple protection features: Low voltage cut-off protection for lithium or nickel battery / Over-heat protection / Throttle signal loss protection / Motor blocked protection/
5. í¬ì¼“ í¬ê¸°ì˜ 프로그램 카드와 쉽게 프로그램ë˜ê³ 호환ë©ë‹ˆë‹¤.
6. ì €ì „ì•• 차단 : ì´ ê¸°ëŠ¥ì€ ì£¼ë¡œ 리튬 배터리 íŒ©ì´ ê³¼ë°© ì „ë˜ëŠ” ê²ƒì„ ë°©ì§€í•˜ê¸°ìœ„í•œ 것입니다. 리튬 배터리 íŒ©ì„ ì‚¬ìš©í• ë•ŒëŠ” ì €ì „ì•• ë³´í˜¸ì— ì í•©í•œ ê°’ì„ ì›í•˜ëŠ”대로 ì„¤ì •í•˜ì‹ì‹œì˜¤. ê²½ê³ : 리튬 배터리ì—는 기본값 "비보호"를 사용하지 마ì‹ì‹œì˜¤! 3.1V,2.9V,2.7V,비보호
(ê¸°ë³¸ê°’ì€ 3.1V)
8. 3 시작 모드 ( "펀치 (Punch)"ë¼ê³ ë„ í•¨)를 "소프트"ì—ì„œ "매우 공격ì ì¸" (기본값 중간)
9. 최대 ì œë™ë ¥ : (25A,35A,45A,60A)50 %,25 %,75 %,100 %(기본값 50 %), (80A,120A)25 %,50 %,75 %,100 %(기본값 25 %)
10. 최대 ì—ë°©í–¥ 힘 : 25 %,50 %,75 %,100 %(기본값 25 %)
11 : 중립 범위 : 9 % (ì¢ìŒ),6 % (보통),12 % (ê´‘ì—) (기본값 9 %)
명세서
ëª¨ë¸ |
25A |
35A |
45A |
60A |
80A |
120A |
|
Cont. ì „ë¥˜ / 버스트 ì „ë¥˜ |
25A/100A |
35A/120A |
45A/180A |
60A/320A |
80A/480A |
120A/600A |
|
모터 ìœ í˜• |
센서리스 브러시리스 모터 |
ì í•©í•œ ìžë™ì°¨ |
1/24,1/18, 1/16 ì°¨ |
1/18, 1/16,1/14 ì°¨ |
1 / 12.1 / 10 ì°¨ |
1/10 ì°¨ |
1/8 ì°¨ |
1/8 ì°¨ |
ì í•©í•œ 브러시리스 모터 |
> = 12T ì´ìƒ |
> = 12T ì´ìƒ |
9T ì´ìƒ |
9T ì´ìƒ |
> = 5.5T |
> = 3.5 |
ì €í• |
0.004ohm |
0.003ohm |
0.0014ohm |
0.0007ohm |
0.0005ohm |
0.00035ohm |
배터리 |
2 ì„¸í¬ Lipo
4 ~ 6 ì…€ NiMH |
2 ~ 3 ê°œì˜ ì„¸í¬ Lipo
4 ~ 6 ì…€ NiMH |
2 ~ 3 ê°œì˜ ì„¸í¬ Lipo
4 ~ 9 ì…€ NiMH |
2 ~ 4cells Lipo 4 ~ 12cells NiMH |
2 ~ 6cells Lipo 4 ~ 12cells NiMH |
BEC ì¶œë ¥ |
5V/2A
(ì•„ë‚ ë¡œê·¸ 모드) |
5V/2A
(ì•„ë‚ ë¡œê·¸ 모드) |
5.8V/3A
(스위치 모드)
|
6.1V/3A
(스위치 모드) |
치수 |
25*30*14.5mm |
25*30*18.5mm |
32.5*34*24mm |
41*51*36mm |
I견해
1. ìˆ˜ì‹ ê¸°ì™€ BEC ì „ì„ ì—°ê²°
2. Connect motor wires with ESC
3. 트랜스미터를 켜ì‹ì‹œì˜¤.
4. Connect battery pack with ESC then switch on the ESC.
5. 모터와 ë°°í„°ë¦¬ì˜ ì—°ê²°ì´ ë나면 모터는 "ì‚ - ì‚"소리를냅니다.
6. When the throttle stick is in the neutral position, the motor re-emits “Beep-Beep†tone.
7. ESC는 ì‹¤í–‰í• ìˆ˜ 있습니다.8. 커넥터 : 4.0 T PLUG
프로그램 방법
1. BEC ì „ì„ ì„ í”„ë¡œê·¸ëž˜ë¨¸ì™€ ì—°ê²° í•œ ë‹¤ìŒ ESC를 ì¼ë‹ˆë‹¤.(80A,120A는 키를 눌러 놓지 않습니다.)
2. 녹색 LEDì´ ë‘ ë²ˆ 깜박 ì¸ í›„ LED 꺼ì§, 즉 ESC가있는 ì—°ê²° 프로그래머가 성공ì 으로 실행ë˜ê³ 빨간색 LEDì´ ì¼œì§€ë©´ 해당 í•ëª©ì˜ 현재 ê°’ì´ í‘œì‹œë©ë‹ˆë‹¤. ê·¸ë ‡ì§€ 않으면 ì—°ê²°ì´ ì‹¤íŒ¨í•©ë‹ˆë‹¤.
3. Please press the Key “↓†to select different programs
4. "→"키를 눌러 현재 í”„ë¡œê·¸ëž¨ì˜ ë‹¤ë¥¸ ê°’ì„ ì„ íƒí•˜ì‹ì‹œì˜¤
5. Please press the Key “Program†to confirm above selections, the Green LED on immediately and has gone out within 5 seconds, that is, this process is successful.
6. "Reset"키를 눌러 초기 ì„¤ì •ì„ ìž¬ì„¤ì •í•˜ì‹ì‹œì˜¤.
ë¬¸ì œ í•´ê²°
1. ì „ì›ì„ ì¼ í›„ì—ë„ ëª¨í„°ê°€ ìž‘ë™í•˜ì§€ ì•Šê³ ì†Œë¦¬ê°€ 나지 않으면 배터리 팩과 모터 사ì´ì˜ ì—°ê²°ì„ ì 검하ì‹ì‹œì˜¤.
2. If after power on, LED flashes, please check the voltage of battery pack, which should be from 5V~13V.
3. 모터ì—ì„œ "ì‚ - ì‚"ìŒì´ 들리면 BEC ì „ì„ , ì†¡ì‹ ê¸° ë° ìˆ˜ì‹ ê¸°, 스로틀 ì‹ í˜¸ ì „ì„ ë“± ëª¨ë“ ì—°ê²°ì„ ì 검하ì‹ì‹œì˜¤.
4. If the car can’t be speed up, please check either voltage of the battery pack is too low or the temperature of ESC is too high. If the voltage of the battery pack is too low, please replace the battery pack. If the temperature of ESC is too high, please check all connections.
5. ìš´ì „ 중 ì°¨ëŸ‰ì´ ê°‘ìžê¸° 멈출 경우 ëª¨í„°ì˜ ì—°ê²° ìƒíƒœë¥¼ 확ì¸í•˜ì‹ì‹œì˜¤.
6. If the car runs in the opposite direction, which the transmitter is available, please swap two wire connections between the ESC and the motor.
패키지 í¬í•¨ :
1xESC