2S 3A リチウムイオン電池 18650 保護充電器ボード BMS PCB ボード
レビューの一部は自動翻訳されています。
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
素早く到着しました
非常に良いお勧め🤝🏿
外部モジュールr9m用の外部バッテリーイオンを保護するために購入しました。 はんだ付けするパッドは繊細です。 385°では、彼らは取り外して移動します。
高速配信。正常に動作します
good quality, it's working, very small dimensions
非常に早く到着したのですが、試すことはありませんが、試すと良い感じです
nice and small
K 非常に良い。