सभी संदेश

क्यू: What USB connector is required to program and are the drivers for this compatible with windows 10?

द्वारा पूछा गया BG111545948 पर 2020-08-04 03:45:59

CodfishCatfish It uses a Micro USB connector and is programmed with the Arduino IDE. You may have to search the Boards manager for the correct driver. If just using the ESP8266 part then that will need the correct driver. If using the Mega2560 part then that is already included in the latest Arduino IDE. DIP switches allow you to select which programming area.

2020-08-04 03:58:20 उपयोगी (0)
जमा करें
जवाब (2)

क्यू: What filament can it use

द्वारा पूछा गया BG113354171 पर 2020-06-08 01:48:02

CodfishCatfish I have successfully used PLA, ABS and TPU but you will have to adjust your settings for each. Some filaments require different Nozzle and Bed temperatures.

2020-06-08 02:17:23 उपयोगी (0)
जमा करें
जवाब (1)

क्यू: it is suitable for balance charger imax b6??

द्वारा पूछा गया jaydeep505 पर 2018-07-01 10:45:53

CodfishCatfish Yes this should fit bit only the plug side.

2020-05-29 09:29:01 उपयोगी (0)
जमा करें
जवाब (1)

क्यू: ok for tx and rx cell booster ?

द्वारा पूछा गया BG573717452 पर 2020-05-28 08:29:43

CodfishCatfish No, this is a LNA or low noise amplifier. It can only receive RX and cannot TX.

2020-05-29 09:27:46 उपयोगी (0)
जमा करें
जवाब (1)

क्यू: Does this include the extruder with a blue silicon case and cooling fan?

द्वारा पूछा गया BG314865537 पर 2020-05-29 08:57:06

CodfishCatfish The extruded has an ABS case as seen in the picture with a Silicon cover inside that. There are two fans attached to the extruded head. One is an extruded cooling fan and the other a snail fan for cooling the print job.

2020-05-29 09:25:58 उपयोगी (0)
जमा करें
जवाब (1)

क्यू: Does it have an I2C bus?

द्वारा पूछा गया Andy पर 2020-02-29 02:05:38

CodfishCatfish Yes it does on Pin 20 and Pin 21.

2020-03-05 12:27:42 उपयोगी (0)
जमा करें
जवाब (1)

CodfishCatfish If you see the description it indicates Input and output on the same pins. You charge with the same pins as your output. Just as if you were charging a 12v SLA, the battery board takes care of balancing and battery overvolt and short as well as low voltage cutoff. So yes use the same output pins to charge as they are output and input. However, depending on the model you will need more voltage that 12v for 11.1v as 3x18650 = 4.2vdc fully charged so more than 12.6v.

2020-02-02 04:00:14 उपयोगी (2)
जमा करें
जवाब (1)