كل الرسائل

hwij Did not use BNC for ages - but you can measure using multimeter: - other end open, no connection between centre pin and shield - Terminator at other and 50 OHM between these

2022-07-03 07:57:27 مساعدة (0)
عرض
أجابات (3)

سؤال: Does this support dual boot?

السؤال بواسطة Deviantfly على 2021-10-15 10:54:51

hwij Worked for me with GRUB (server died after 14 months) If you have OS installed on 2nd drive, you can also choose from boot menu

2021-12-01 05:34:14 مساعدة (1)
عرض
أجابات (2)

سؤال: what is the purpose of switch s1?

السؤال بواسطة Anto على 2021-09-16 03:53:24

hwij According to text next to schematics: It can switch cycle and frequency display

2021-10-15 10:14:51 مساعدة (0)
عرض
أجابات (2)

سؤال: Will this one work on Orange PI?

السؤال بواسطة hwij على 2018-02-14 04:20:42

drcyberg Yes

2021-08-22 03:55:32 مساعدة (0)
عرض
أجابات (2)

سؤال: Thank you. So what do the specs below "Signal source indicator" on the DSO2C10 page, mean?

السؤال بواسطة BG444816485 على 2020-12-06 06:24:55

hwij If you mean the "slash" on this page: it has no signal generator, only the "D" ones do (where it says 1ch)

2020-12-16 01:51:13 مساعدة (0)
عرض
أجابات (1)

سؤال: "Supports up to 1TB 2.5-inch SATA hard drives" but no SATA port?

السؤال بواسطة hwij على 2018-04-14 05:36:35

Luke yes the hard drives can connect through x820

2018-04-18 09:40:55 مساعدة (0)
عرض
أجابات (1)

hwij Worked right after assembly, voltage control worked opposite from expected (turning clockwise lowers the voltage). Got from pictures here that red wires on transformer are 230V, I could not tell from anything in package or indication on transformer.

hwij 15/11/2017
0
تعليقات (3)