Carte de charge de protection de batterie au lithium 18650 Li-ion 2S 3A Carte BMS PCB
Une partie de la critique a été traduite automatiquement.
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
Arrivé rapidement
très bien recommande 🤝🏿
acheté pour protéger les batteries externes eux ion pour le module externe r9m. Les coussinets à souder sont délicats. À 385° ils se détachent et se déplacent.
Livraison rapide. Fonctionne bien
good quality, it's working, very small dimensions
est arrivé très vite encore je ne l'essaye pas mais il semble bien quand je l'essaye je vais commenter plus
nice and small
O K Très bien.