Una parte de la reseña se ha traducido automáticamente.
So far tested just on bench. RE & DE can be connected and be driven by only one signal line, because RE (enable receiver) is active low and DE (enable transmitter) is active high. Note: in such configuration protocol have to be able to ignore possible noise on the bus. All signals are connected to pins and bus is also connected to screw terminals on top side of module. Note: polarity of bus lines is important and needs to be same on all transceiver on bus. Due to IC datasheet (it's MAX485) there can be 32 transceiver on one bus.
They look good. I didn't test them yet but I assume they will work fine.
Producto según la descripción del anuncio
This should be in a "bus" kit for Arduinos as it is a good education tool for learning all the micro busses, like RS232, RS485, I2C, SPI, CANBUS, etc.
Excelente relación calidad-precio y buen servicio
Producto conforme. Funcional.
Bueno
De acuerdo
excelente
Llegó a tiempo a pesar de las restricciones de viaje debido a Covid-19. Estaba debidamente empaquetado y en buen estado. Pero aún no lo he probado.