I like that they are some kinda invisible. If i use them for vibration isolation? No way, there are better stuff out there for that job. However to isolate your PDB from your frame or your VTX connector form your frame, or anything else that would get ground to your frame, go ahead! Great electrical isolators for all necessary places on your Drone :) "Put 1 one top and one bottom of all the standoffs of your FC, best softmount ever!" Bullshit... the screws are still translating the vibrations to the pdb of whatever you wanted to softmount that way :)= Use rubberized standoffs, much better. Or drill out, the wholes on your board to 4mm and use the Diatone/Revolt grommets that fot in the holes directly! Thats what isolates it completely from the frame, not these o-ring-o-madness-put-a-ton-on-top-and-bottom-of-your-fc Still, like them :D

I like that they are some kinda invisible. If i use them for vibration isolation? No way, there are better stuff out there for that job. However to isolate your PDB from your frame or your VTX connector form your frame, or anything else that would get ground to your frame, go ahead! Great electrical isolators for all necessary places on your Drone :) "Put 1 one top and one bottom of all the standoffs of your FC, best softmount ever!" Bullshit... the screws are still translating the vibrations to the pdb of whatever you wanted to softmount that way :)= Use rubberized standoffs, much better. Or drill out, the wholes on your board to 4mm and use the Diatone/Revolt grommets that fot in the holes directly! Thats what isolates it completely from the frame, not these o-ring-o-madness-put-a-ton-on-top-and-bottom-of-your-fc Still, like them :D

I like that they are some kinda invisible. If i use them for vibration isolation? No way, there are better stuff out there for that job. However to isolate your PDB from your frame or your VTX connector form your frame, or anything else that would get ground to your frame, go ahead! Great electrical isolators for all necessary places on your Drone :) "Put 1 one top and one bottom of all the standoffs of your FC, best softmount ever!" Bullshit... the screws are still translating the vibrations to the pdb of whatever you wanted to softmount that way :)= Use rubberized standoffs, much better. Or drill out, the wholes on your board to 4mm and use the Diatone/Revolt grommets that fot in the holes directly! Thats what isolates it completely from the frame, not these o-ring-o-madness-put-a-ton-on-top-and-bottom-of-your-fc Still, like them :D

It is not very soft as the silicone rubber is supposed to. But it does the job good. Thanks to BG

It is not very soft as the silicone rubber is supposed to. But it does the job good. Thanks to BG

It is not very soft as the silicone rubber is supposed to. But it does the job good. Thanks to BG