Alle Nachrichten

Q: what is the diameter of the hole required for this device?

gefragt von Coetz auf 2017-12-16 08:18:04

Maminbot 46 mm or 1.8 inch exactly. So you will need a slightly larger bore with some gap as leeway. However bear in mind that the barrel does not come with a tensioning mechanism so you may need to pack it with some foam, otherwise it may rattle about. The surface cap diameter overhang is 67.8 mm or 2.67 inch.

2018-01-17 07:34:52 Hilfreich (1)
Vorlegen
Antworten (1)

Q: Where is the power supply?

gefragt von Glauve auf 2017-12-26 12:14:40

Maminbot The 3 USB sockets are directly attached to a circuit board with a switch mode power supply. It's all contained in the tube below the surface.

2018-01-17 07:21:14 Hilfreich (0)
Vorlegen
Antworten (1)