Kundenbewertungen

Eine Bewertung schreiben
  • Alle Bewertungen (500)
  • Bild (48)
  • Video (0)
  • Alle Sterne
    • Alle Sterne(500)
    • 5 Sterne(454)
    • 4 Sterne(40)
    • 3 Sterne(3)
    • 2 Sterne(0)
    • 1 Sterne(3)
Sortiere durch:
Zur Vorschau
  • Zur Vorschau
  • Am hilfreichsten
  • Die letzten
Bewertungen nur aus Ihrem Land (United States)
|
Original zeigen

Ein Teil der Rezension wurde automatisch übersetzt.

  • 18/08/2015

    I used this module to build a variable power supply. I use an input voltage of 12 volts (from a computer power supply) and need this module to create a variable (settable via the potmeter) output voltage ca 1 - 30 volt. With output voltages over 12 volts everything works fine. In the step down mode (voltages below 12 volt) the output voltage is not stable. For instance if I set the output voltage to 5 volts and apply no or very little load, then the outputvoltage "swings" between 4.8 and 5.3 volt. This only stops if I apply a larger load that draws at least 500mA of current.

    Kommentar
    Original zeigen
  • 24/05/2020

    Tolles Produkt. Ich habe es verwendet, um ein Bank-Netzteil mit 2 variablen Kanälen zu bauen und es funktioniert einwandfrei.

    Kommentar
    Original zeigen
  • 09/05/2021

    Ich testete es mit meiner Arbeitsplatte Quelle und legte ein Multimeter auf den Ausgang und stellte es für eine niedrige Spannung Auslass. Es war nicht warm. Aber ich würde die größte Sorgfalt empfehlen, um die Einreisespannungen nicht umzukehren, weil es zu Problemen führen kann. Sehr klein und sehr kompakt. Ich empfehle diesen Artikel. Schauen Sie sich die Fotos an und mögen.

    Kommentar (1)
    Original zeigen
  • Antonin
    FR
    11/07/2020

    Sehr gut, Schiff mit Antistatik-Tasche. Produkt wurde richtig verpackt. Line-Regelung ist gut, getestet mit 5-30v im Eingang, und 2A Last. Geeignet für LED, oder kein analoges Gerät ohne Filter. Strombegrenzung funktioniert einwandfrei. Ich bin etwas enttäuscht von der Kondensatorauswahl. Es sind 105 Grad, aber nur 35V. 50V hätten eine bessere Lebensdauer ermöglicht.

    Kommentar
    Original zeigen
  • 29/08/2017

    This is excellent step-up/step-down converter, that can be used for simple bench power supply. Replace variable resistors with these panel mounting 250 KOhm potentiometers ( http://bit.ly/2wOHvro ), add solid power supply ( http://bit.ly/2wOrJfY ) voltage/current monitor ( http://bit.ly/2wOrWjg ) and put everything in a nice box ( http://bit.ly/2wOHVOu )

    Kommentar
    Original zeigen
  • 08/08/2017

    this converter can help you in solving many power supply problems. it is able to increase or decrese the voltage at its output terminal compared to the input voltage. the output is quite stable with the load change and the multi turns trims help you in adjusting the output voltage level and the max output current as per your needs. One of the thermal pad below the MOSFET was slightly out of position, but I solved this issue very quickly - check the pads before power up the circuit. good value for money. suggested questo convertiore permette di aumentare o diminuire la tensione in uscita rispetto al valore della tensione di ingresso. la tensione di uscita è stabile rispetto alle variazioni della corrente del carico. i trim multigiri permettono una buona regolazione della tensione e della massima corrente di uscita. Un MOSFET aveva il pad termico leggermente fuori posto, ma ho risolto velocemente il problema. suggerisco un controllo dei pad termici prima di dare tensione al circuito ottimo valore per il prezzo. suggerito

    Kommentar
    Original zeigen
  • 24/10/2016

    Seems to work well. I will use it to have a portable power pack for all situations (recharge PC, drone Lipos, etc.). Will see how it hold up in time.

    Kommentar
    Original zeigen
  • 05/07/2016

    Преобразователь из низкого напряжения от 1.5 вольт может заряжать аккумулятор 12-24 вольта,правда при этом достаточно сильно греется.

    Kommentar (1)
    Original zeigen
  • 23/06/2017

    I am using this to boost battery voltage to supply power into a class D amplifier. Now I can use full volume without clipping.

    Kommentar
    Original zeigen
  • 15/05/2019

    Works great and it doesnt heat up. Used a 12V SMPS with this and can only reach 1.1V - 29V. I hoped to reach 30V but this has the best value for buck boost converters here. 5 stars!

    Kommentar
    Original zeigen
Show:

    Gesamt 0 Seiten

    Zur Seite gehen

    Sie interessieren sich vielleicht für:

    recommendation for you
    • US$12.99
    • US$5.99
    • US$7.49
    • US$2.99
    • US$7.99
    • US$1.99
    • US$3.99
    • US$1.99
    • US$0.99
    • US$4.99
    • US$33.99
    • US$94.99
    • US$96.59
    • US$36.00
    • US$1.40
    • US$1.99
    • US$3.99
    • US$4.99