Darren
Meu conteúdo
Todas as mensagens
Comentários
Comentários
respostas
Questões

Todas as mensagens

Darren 30/10/2018
Mine arrived in very poor condition, both lenses were floating and not secured properly. The 2x 18650's used in mine were generic Chinese cells and had a real capacity of 2000mAh not 2200mAh. On the stock generic cells the runtime on full was respectable at a few hours. I modded mine and upgraded to 2x Sanyo NCR18650GA's which had a very noticeable effect on the runtime. Don't try to do this unless you are comfortable with soldering as it's not a simple or particularly easy job, you will need to spot weld your new cells together and swap over the battery protection and then squeeze everything back into the aluminium body. I did not notice much if any increase in output from changing the wires to a larger AWG or the lower resistance cells, I would assume this is because the stock wires are sufficient and the light is regulated. I did not do any current measurements but going by the output in comparison to another genuine Cree torch I would say it is around 1000 lumens MAX. The heat sinking to the main aluminium body is near enough non existent but the small contact area it does have did not have any thermal compound, I am extremely surprised it runs as well as it does. Overall it's a nice looking light that works well but the actual spec is WAY off, my estimate would be 1000 lumen 5500K 75CRI with a 4000mAh battery which in comparison to the leading brands of bike lights makes this still well worth the money!
XANES DL07 1800LM 2*L2 4400mAh recarregável Bateria luz indicadora de bicicleta
US$31.99 US$38.99
4
Recomendações
Comentários (1)
Darren 01/12/2018
Nice quality straps!
Fita de amarração Magic Tape da RJX HOBBY para bateria RC
US$6.99 US$8.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
Seem decent for the money, they also use silicone wire which is much better than the cheaper ones I have seen.
Cabo Fio de Extensão Carregamento Equilíbrio Bateria Li-Po 20cm 2S 3S 4S 6S
US$4.99 US$5.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
I wish they did larger packs of this, it's good stuff!
127Pçs Livre de Halogênio 2:1 Tubo Termorretráctil Conjunto de Enrolamento de Mangas Cabo Fio
US$7.99 US$12.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
The heat resistance of this tape is great.
Fita Resistente a Calor Película de Poliimida Temperatura Alta 5 Tamanhos
US$3.99 US$4.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
Good for the money!
Cabo de Balanceamento LiPo JST-XH 2S 3S 4S 5S 6S para Cabo de Carregamento de Energia 10CM
US$6.00 US$11.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
I have purchased a few of these now and can honestly say they are quite good. Well done Banggood!
Módulo de Equilíbrio de Células da Placa de Proteção de Bateria de Lítio 18650 Li-ion 14S 45A 52V
US$22.99 US$27.99
0
Recomendações
Comentários (0)
Darren 01/12/2018
I had lots of problems with this, it seems much more inaccurate than a regular ruler and the solar part of it is useless under led light (which is not a surprise).
150 milímetros lcd ferramenta paquímetro digital de fibra de carbono de medição solar composta
US$16.99 US$20.99
0
Recomendações
Comentários (1)
TRONXY® X5ST-400 Kit de impressora 3D de alumínio DIY 400 * 400 * 400mm Tamanho de impressão grande
US$389.99 US$505.99

Q: I have the Tronxy XY-08N level sensor for the X5ST, how do I enable it?

perguntado por Darren sobre 2018-11-30 01:23:18

Waddleeeenn if it is plug and play type, can use directly

2018-12-04 09:34:44 Útil (0)
Enviar
respostas (1)
Darren 28/11/2018
This printer is awful. It came with absolutely no instructions what so ever and the bed is totally warped which makes it useless. If you use glass over the top you will have uneven heating and possibly bend or break the glass. The extruder motor is also faulty. The printer was also supplied with some 3d printed parts which I would not expect from a printer kit of this value. The only good thing about is all the revised parts from all of the other versions of it like the X5S etc.
TRONXY® X5ST-400 Kit de impressora 3D de alumínio DIY 400 * 400 * 400mm Tamanho de impressão grande
US$389.99 US$505.99
3
Recomendações
Comentários (1)
TRONXY® X5ST-400 Kit de impressora 3D de alumínio DIY 400 * 400 * 400mm Tamanho de impressão grande
US$389.99 US$505.99

Q: I have the sensor to upgrade my X5ST 400 but how do I turn on the firmware support?

perguntado por Darren sobre 2018-11-23 12:21:51

Lovable what sensor

2018-11-27 03:13:58 Útil (0)
Enviar
respostas (1)
Darren 30/10/2018
Good stuff. I have not tested it's resistance to heat or flames but it seems just like all the other insulation tapes I have used. It also has a nice pattern embossed into it which makes it look a bit more expensive than regular insulation tapes (which it is).
Fita isolante elétrica 10M Fita adesiva elétrica doméstica
US$2.99 US$4.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
This alarm is quite good quality and functions well. The range of the remote is very good, the LED is quite bright and the battery life is good.
ANTUSI 3 em 1 Luz traseira sem fio para bicicleta Controle remoto Alarme de bloqueio Luz de bicicleta de montanha
US$24.99 US$38.00
0
Recomendações
Comentários (0)
Darren 30/10/2018
I have purchased quite a few of these and they have always been of reasonable quality. The price has increased over the last few months though.
Suporte de bateria DIY para 10pcs com 4 slots para baterias 18650 e 8 fios
US$15.99 US$26.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
These will not accept a heavy AWG wire. They perform OK and are pretty sturdy but if you want to use them at high current due to their "copper" material then you should probably look for something else as they simply will not accept more than 12AWG.
DANIU P3008 10Pcs 4mm Cobre Banana Plug Sondas de teste de amplificador de alto-falante Jack Conector
US$11.99 US$14.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
Very nice fitting covers!
Capa protetora de plástico para plugue XT60 Spark de 3 peças para drone de corrida RC multirotor FPV
US$5.99 US$8.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
Very nice stuff, it's reasonably priced and performs very well under extremely high temperatures.
Fita Resistente a Calor Película de Poliimida Temperatura Alta 5 Tamanhos
US$3.99 US$4.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
The quality of these vary massively. I have had 2 batches of these and there is a huge difference in quality. The first batch was really good quality and fitted very nicely but the second batch was really bad. It's the chance you take I guess when buying from China.
20 Pares de Plugue Banana Amass 4.0mm AM-1003E Macho e Fêmea
US$24.99 US$29.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
This stuff is quite good, I have not done any resistance tests but there is a noticeable quality difference when comparing this against another 8AWG silicone wire. I can't totally recommend this wire without doing a resistance test but I will say that going by the quality it will most likely be good stuff.
1M 8/10/12/14/16/18/20/22/24/26 AWG Fio de silicone SR Wire
US$5.99 US$6.99
0
Recomendações
Comentários (0)
Darren 30/10/2018
These are a very very tight fit, I had to warm mine up to make them fit but after that they fitted perfectly.
Capa Protetora AMASS XT60 XT90-S Anti-spark TPU para Impressão 3D de Cabos de Modelagem RC (2 Unidades)
US$5.99 US$7.99
0
Recomendações
Comentários (0)

Você é o especialista, pode ajudar?

Sinceramente, o convidamos a se inscrever para receber o e-mail de resposta ao convite!

Se você se inscrever, nós o convidaremos por e-mail para responder a perguntas que as pessoas tenham sobre os produtos. Ao se inscrever, você] também ganhará o "Emblema de útil "! Você pode cancelar a assinatura a qualquer momento na página de configurações de privacidade.

Ajude os outros e seja mais feliz!

  • Se inscrever

Sobre crachás

Os crachás estão relacionados à comunidade e os usuários ganham crachás criando conteúdo de qualidade, completando missões ou participando de atividades especiais. Pessoas específicas também terão seu crachá exclusivo.
Crachá do CEO

O Distintivo do CEO pertence apenas ao chefe da Banggood.

Os crachás que pode ganhar está chegando em breve
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe