Všechny zprávy

Madav65@bikinidan I suspect you are correct on the manufacturer. Thanks for the info. on the protocol, I\'ll have a go at binding my Jumper Tx to it.

Madav65 09/10/2021
A nicely finished little model with more scale detail than the Mustang or Trojan. I already own both of these and I guess I was expecting a similar flying experience from this model. Unfortunately out of the box this is extremely nose light . I'm still working on the optimum Cg position but pushing the battery as far forward as possible and a second battery pushed in behind to act as ballast has greatly improved it. I will probably try a larger battery rather than just carrying deadweight, there is ample room for this. As supplied there is a massive amount of down trim on the ailerons, If this was intentional it makes the nose light issue even worse. I reset mine to a neutral position. Flight tests so far are much improved with the more forward Cg and the control surfaces set correctly. Keep the speed up in turns as it will drop a wing if slowed down too much. Make sure that you use the small headed screws to attach the tailplane. These fit inside the fueselage properly to allow correct attachment. This model has lots of potential and will be fine once trimmed out correctly. Sadly it is just not as well sorted as the previous warbirds, which are a pleasure to fly straight out of the box. Beginners will be better off starting with one of these as the P47 needs more work to get it to fly well. If I can work out what RC protocol this uses I will try binding it to my Jumper transmitter. This model really needs some expo setting up to allow it to fly to its full potential. Unfortunately it doesn't seem to use the same one as the Mustang and Trojan , which both benefited from a 40% expo setting on ailerons and elevator.
0
Komentáře (5)
Madav65 09/10/2021
A nicely finished little model with more scale detail than the Mustang or Trojan. I already own both of these and I guess I was expecting a similar flying experience from this model. Unfortunately out of the box this is extremely nose light . I'm still working on the optimum Cg position but pushing the battery as far forward as possible and a second battery pushed in behind to act as ballast has greatly improved it. I will probably try a larger battery rather than just carrying deadweight, there is ample room for this. As supplied there is a massive amount of down trim on the ailerons, If this was intentional it makes the nose light issue even worse. I reset mine to a neutral position. Flight tests so far are much improved with the more forward Cg and the control surfaces set correctly. Keep the speed up in turns as it will drop a wing if slowed down too much. Make sure that you use the small headed screws to attach the tailplane. These fit inside the fueselage properly to allow correct attachment. This model has lots of potential and will be fine once trimmed out correctly. Sadly it is just not as well sorted as the previous warbirds, which are a pleasure to fly straight out of the box. Beginners will be better off starting with one of these as the P47 needs more work to get it to fly well. If I can work out what RC protocol this uses I will try binding it to my Jumper transmitter. This model really needs some expo setting up to allow it to fly to its full potential. Unfortunately it doesn't seem to use the same one as the Mustang and Trojan , which both benefited from a 40% expo setting on ailerons and elevator.
0
Doporučení
Komentáře (5)

Q: How can I reset it ? Tow motors don't work!!!

zeptal se abdu567 na 2021-10-18 12:44:55

Madav65 It'slikely that the motors have failed or the MOSFETs on the control circuit board have fried. The little coreless motors on these small quads don't last long unfortunately. There is nothing you can reset. You can replace the motors but it depends on your skill level with a soldering iron.

2021-10-18 07:14:11 Ochotný (0)
Předložit
odpovědi (0)

Q: what is the flight APP?

zeptal se ace811 na 2021-10-10 09:46:52

Madav65 It's RX Drone. You can find it on the App store

2021-10-11 12:38:10 Ochotný (0)
Předložit
odpovědi (2)

Q: is there any lights compatible with this plane?

zeptal se BGDom93204 na 2021-09-30 09:42:53

Madav65 Nothing as far as I know. The plane is very small so would not be able to carry much extra weight, It's only 1s with no extra space to carry additional batteries. It may however be possible to fit a few individual led's as navigation lights powered from the main battery. You would need to cut into the plane to access the wiring to do this though.

2021-09-30 04:07:09 Ochotný (0)
Předložit
odpovědi (2)

Q: Is lbt or fcc

zeptal se BG154363840 na 2021-08-29 06:51:41

Madav65 It works on D8 protocol, so neither actually. Any transmitter capable of D8 will work with it.

2021-09-27 06:33:51 Ochotný (0)
Předložit
odpovědi (1)

Q: What is the operating voltage for these connectors ?

zeptal se Trex na 2018-12-26 10:16:44

Madav65 These are fairly limited on the amps that they can carry. I would only use them on small models that don't draw much current. 5 amps absolute maximum. Ok for 1s or 2s small batteries .

2021-09-26 12:08:44 Ochotný (0)
Předložit
odpovědi (2)

Q: Does the product have a battery in the plane?

zeptal se BG162121025 na 2021-07-09 08:42:21

Madav65 Depends which version you buy. It is available as just the quad with no batteries or controller or can be shipped with one, two or three batteries. Also you can choose a case or a backpack to carry it in. Read the description carefully to make sure you get the one you want. I would recommend at least two batteries.

2021-09-26 12:04:42 Ochotný (0)
Předložit
odpovědi (1)

Q: This Transmitter have receiver.?

zeptal se BG616531806 na 2021-09-26 10:25:07

Madav65 It doesn't come with a receiver as it can bind to many different ones. The 4 in 1 version is the one to get as it will bind to most receivers.

2021-09-26 12:00:39 Ochotný (0)
Předložit
odpovědi (1)