AD584 4 Channel 2.5V/7.5V/5V/10V High Precision Voltage Reference Module With Transparent Housing
A part of the review has been auto-translated.
Its a good way to compare multi meters. Sadly I have no certified nor perfectly calibrated device to check the precision of this reference. I just wanted to check the deviation of my meters and it looks good for me by using this reference. First of all, I soldered a spare LiPo I had laying around that fits into the case. I never would use an unstable USB input to measure my meters. USB charging works perfectly, but the battery looses energy over time. Possible that this device eats some micro ampere, even if its off. But it charges fully in a short time. I tested it with a Vichy VC99 (about 10yrs old), ANENG AN8002 (about 4 yrs old) and UNI-T UT204+ (5 months old). Results were: Vichy VC99: 2.498V | 5.000V | 7.49V | 9.99V UNI-T UT204+: 2.501V | 5.006V | 7.49V |9.99V ANENG AN8002: 2.494V | 4.991V | 7.48V | 9.97V Closest one was my bulky Vichy VC99 and the worst result has my ANENG AN8002. But in the end I'm ok with the result and I will still use all of these 3 meters as the worst measured value was just 0.3% off.
It's a good device, the rations are weirdly good on the board. The only thing that's upsetting is that there's no check mark sheet included, so I'm going to look for a reference device to make these measurements. The packaging is good, the goods arrived without damage. I bought the battery separately, everything works and the battery is charged. I haven't tested for sure yet, but from the first tests, my readings don't depend on the supply voltage, for example, on the discharged ACB and the fully charged readings are the same, which is pleasing. I wanted to put the socket on the ACB board, there's even room for it, but because of the nests, it doesn't. I haven't removed the protective film from the plexiglas yet. I'm satisfied with the purchase, everything's fine. Bangood, as always, pleased! I recommend!
great product. tested on my Fluke meter I borrowed from mu lab and its pretty spot on.
OK, countertop tool...
Is operating point
Всё хорошо. Ещё не проверил
It works great! I love that I can just add a Lithium Ion rechargeable to it and it includes a 5V switching upconverter and a charge controller that charges it from micro USB. Before you add a battery, it will gladly run from USB power. I am only subtracting stars because the wires are barely soldered onto the banana jacks, and the wires to the power switch are soldered to a couple of surface mount parts, not to pads on the board. The rest of the construction is great! No instructions included. Operation is fairly simple, plug it in, and press the button for about 1 second to switch between voltages. It should at least include instructions on how to connect a LiIon cell. Use the B+ and B- to connect a single LiIon cell. It makes me a bit nervous that the banana jacks are just open holes. I was extra careful putting my meter's test leads in there. It would be easy to short it to some part of the PCB. If you want to see the insides, you'll have to take it apart first, because they only peeled the protective paper from the top acrylic piece.
Very good and accurate reference for measurement instruments calibrations. Good to have to verify accuracy or as a precise voltage reference. Not cheap, but worth the price
An indispensable tool for multimeter calibration.
Great little tool. Seems accurate enough down to the millivolt.