Customer Reviews

4.92 out of 5
Write a Review
  • All Reviews (53)
  • Image (5)
  • Video (0)
  • All Star
    • All Star(53)
    • 5 Star(50)
    • 4 Star(2)
    • 3 Star(1)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
  • November-13 2018 20:13:22

    モーター、プロペラ、翼用フィルム、 フレーム用パーツ、ビスのセットです。 受信機、サーボは、含まれていません。 サーボは、リニアサーボ2個ではなく、 TY Model 1.7g Servo With JST 1.0mm Plug Compatible Spektrum 6400 Series Receiver For RC Airplane か、類似品が良さそうです。 リニアサーボを選ぶ場合は、2個1枚基板の物を選んでください。 単体品2個を付ける部品は、付属しません。 受信機は、 2.4G

    Comments
  • April-29 2019 10:13:55

    The airplane is more complicated to build than you think it is. It is not suitable for the beginners. The install manual writes about the three ways to install e receiver and ESC. I found the fourth way. The motor has more power than is needed.

    Comments
  • April-14 2018 11:32:51

    buon prodotto per principianti leggero e divertente da pilotare

    Comments
  • March-14 2019 10:46:49

    excelente estado

    Comments
  • December-05 2017 14:41:06

    hoooo many housr to aassemble this plane many thanks banggood

    Comments
  • April-18 2020 05:50:10

    Very pleased with the kit, it built well and flys better than i expected! Added a little shape to the wing with a bit of cotton across the bottom face of the wing, this helps it fly even slower :)

    Comments
  • March-19 2020 10:08:08

    Arrived on time. Part count shows all is there, I just have to build it!

    Comments
  • September-10 2016 03:29:19

    I ordered this kit because I didn't like the fin shape on the V1. I found various other improvements. The wing fixing is a great improvement on the version V1. It's still fiddly but it works. The packaging of the carbon rod is much better and less prone to breakage. The film covering is now rolled which should eliminate creases. The cutting list for the carbon fibre rod is wrong. It is a copy of the cutting list for the V2. There are only two pieces required for te wing outline - not 4 - and they

    Comments
  • September-02 2016 03:15:41

    Хороший комплект .Отличное качество.суперская доставка ,но без электроники!!Надо докупить плату к WL 925 и акки. This is a good kit. Excellent quality. the super service, but without any electronics !! It is necessary to purchase a Receiver Board to F 925 and Li-po

    Comments
  • May-04 2018 06:02:43

    Do not cut the carbon fiber according to page 1! It has you cut a 103mm section of 1 mm and later you will need 123mm to hold your plane together. Just cut the pieces as you need them. It makes a lesser mistake with 32 vs 30 mm.

    Comments
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$25.99
    • US$29.80
    • US$79.99
    • US$11.54
    • US$22.90
    • US$38.99
    • US$19.99
    • US$69.99
    • US$115.19
    • US$24.14
    • US$89.99
    • US$56.90
    • US$93.99
    • US$89.99
    • US$95.19
    • US$77.99
    • US$88.90
    • US$164.99