Customer Reviews

4.82 out of 5
Write a Review
  • All Reviews (61)
  • Image (7)
  • Video (0)
  • All Star
    • All Star(61)
    • 5 Star(53)
    • 4 Star(5)
    • 3 Star(3)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United States)
  • December-05 2020 02:02:25

    this is excellent and it was easy to install on an skr mini E3 v2. I'm using it only to level using the dedicated bltouch port on the mainboard. I am still homing to z using the normal microswitch. little to no chance of me digging into the bed when homing. perfect adhesion every time! thanks!!

    Comments
  • August-28 2020 18:37:28

    El envío llego en tiempo aceptable y el embalaje correcto. Solo queda probarlo.

    Comments
  • October-27 2020 02:45:57

    was hoping for clear but works nice wire length

    Comments
  • February-26 2020 07:25:37

    looks good, not tested yet..

    Comments
  • November-09 2020 19:56:59

    good

    Comments
  • August-25 2020 14:57:12

    Tutto ok.

    Comments
  • September-30 2020 02:50:24

    works nice in my Tevo Tarantula Pro.

    Comments
  • October-14 2020 07:43:26

    Works as hoped after a lot, a lot of troubleshooting. It did ruin my printer by smashing in the bed a few times. Really need to use the extra delivered connectors when they fit your printer. By using the black ones the connection isn't good and will give you lots of issues. So solder the right connectors, important! Also, glue them in place. The smallest connection issue makes it not work and lets your nozzle press into the bed until all is broken. I would recommend! Assuming you are careful. (not

    Comments
  • August-24 2020 12:27:47

    I found the cable a little short to run inside the cable sleeve otherwise it was an easy install on an SKR E3 Mini 2.0 using the already compiled firmware download from the Bigtree github.

    Comments
  • January-05 2021 08:33:20

    The harness turned out to be a bit too short for comfort to install on an Ender 3 Pro, I had to extend the wires about 10 cm in order to have proper service loops. Other than that, it's been very functional and repeatable.

    Comments
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$16.99
    • US$2.39
    • US$13.48
    • US$8.97
    • US$4.10
    • US$8.99
    • US$18.45
    • US$19.95
    • US$13.99
    • US$35.98
    • US$2.79
    • US$9.82
    • US$12.49
    • US$30.99
    • US$10.35
    • US$7.34
    • US$11.60
    • US$6.99